Further Sanity Checks for Z_PROBE_AND_ENDSTOP.

master
Chris Roadfeldt 10 years ago
parent 8b81f20c61
commit 059052889f

@ -92,12 +92,22 @@
#if Z_MIN_PIN == -1
#if Z_PROBE_PIN == -1
#ifdef Z_PROBE_REPEATABILITY_TEST
#error You must have a Z_MIN endstop to enable Z_PROBE_REPEATABILITY_TEST.
#error You must have a Z_MIN or Z_PROBE endstop to enable Z_PROBE_REPEATABILITY_TEST.
#else
#error ENABLE_AUTO_BED_LEVELING requires a Z_MIN or Z_PROBE endstop. Z_MIN_PIN or Z_PROBE_PIN must point to a valid hardware pin.
#endif
#endif
#endif
/**
* Require a Z Probe Pin if Z_PROBE_AND_ENDSTOP is enabled.
*/
#if defined(Z_PROBE_AND_ENDSTOP)
#if Z_PROBE_PIN == -1
#error You must have a Z_PROBE_PIN defined if you enable Z_PROBE_AND_ENDSTOP
#endif
#endif
/**
* Check if Probe_Offset * Grid Points is greater than Probing Range
*/

Loading…
Cancel
Save