Added Fan control to the pre-heat settings.

I find that the PID routine works better when the cooling fan is switched on
at the beginning of a warm up routine.  Otherwise when you enable the fan
just before a print, you have a delay as the PIDre-adjusts.

This should also be safer as most cooling fans are directed at the hot -ends
thermal barrier!
master
Blair Thompson 13 years ago
parent d9f2f509d5
commit 2fd8c248fe

@ -194,10 +194,16 @@ const bool Z_ENDSTOPS_INVERTING = false; // set to true to invert the logic of t
#define ULTRA_LCD
#define LCD_WIDTH 20
#define LCD_HEIGHT 4
// Preheat Constants
#define PLA_PREHEAT_HOTEND_TEMP 180
#define PLA_PREHEAT_HPB_TEMP 70
#define PLA_PREHEAT_FAN_SPEED 255 // Insert Value between 0 and 255
#define ABS_PREHEAT_HOTEND_TEMP 240
#define ABS_PREHEAT_HPB_TEMP 100
#define ABS_PREHEAT_FAN_SPEED 255 // Insert Value between 0 and 255
#else //no panel but just lcd
#ifdef ULTRA_LCD
#define LCD_WIDTH 16

@ -490,10 +490,10 @@ void MainMenu::showPrepare()
MENUITEM( lcdprintPGM(MSG_SET_ORIGIN) , BLOCK;enquecommand("G92 X0 Y0 Z0");beepshort(); ) ;
break;
case ItemP_preheat_pla:
MENUITEM( lcdprintPGM(MSG_PREHEAT_PLA) , BLOCK;setTargetHotend0(PLA_PREHEAT_HOTEND_TEMP);setTargetBed(PLA_PREHEAT_HPB_TEMP);beepshort(); ) ;
MENUITEM( lcdprintPGM(MSG_PREHEAT_PLA) , BLOCK;setTargetHotend0(PLA_PREHEAT_HOTEND_TEMP);setTargetBed(PLA_PREHEAT_HPB_TEMP);analogWrite(FAN_PIN, PLA_PREHEAT_FAN_SPEED); beepshort(); ) ;
break;
case ItemP_preheat_abs:
MENUITEM( lcdprintPGM(MSG_PREHEAT_ABS) , BLOCK;setTargetHotend0(ABS_PREHEAT_HOTEND_TEMP);setTargetBed(ABS_PREHEAT_HPB_TEMP);beepshort(); ) ;
MENUITEM( lcdprintPGM(MSG_PREHEAT_ABS) , BLOCK;setTargetHotend0(ABS_PREHEAT_HOTEND_TEMP);setTargetBed(ABS_PREHEAT_HPB_TEMP); analogWrite(FAN_PIN, ABS_PREHEAT_FAN_SPEED); beepshort(); ) ;
break;
case ItemP_cooldown:
MENUITEM( lcdprintPGM(MSG_COOLDOWN) , BLOCK;setTargetHotend0(0);setTargetBed(0);beepshort(); ) ;

Loading…
Cancel
Save