From 36771e949252244652dffa1c32502b4fdf49a2d0 Mon Sep 17 00:00:00 2001 From: jneilliii Date: Sat, 26 Aug 2017 03:11:47 -0400 Subject: [PATCH] Fixes required for Creality CR-10 --- Marlin/pins_MELZI_CREALITY.h | 25 ++++++++++++++++++++----- 1 file changed, 20 insertions(+), 5 deletions(-) diff --git a/Marlin/pins_MELZI_CREALITY.h b/Marlin/pins_MELZI_CREALITY.h index b2f0cf871..e9199ed36 100644 --- a/Marlin/pins_MELZI_CREALITY.h +++ b/Marlin/pins_MELZI_CREALITY.h @@ -22,10 +22,17 @@ /** * Melzi (Creality) pin assignments + * + * The Creality board needs a bootloader installed before Marlin can be uploaded. + * If you don't have a chip programmer you can use a spare Arduino plus a few + * electronic components to write the bootloader. + * + * See http://www.instructables.com/id/Burn-Arduino-Bootloader-with-Arduino-MEGA/ */ #define BOARD_NAME "Melzi (Creality)" #define IS_MELZI + #include "pins_SANGUINOLOLU_12.h" // For the stock CR-10 use the REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER @@ -33,19 +40,27 @@ #undef LCD_SDSS #undef LED_PIN - #undef LCD_PINS_RS #undef LCD_PINS_ENABLE - -#define LCD_PINS_RS 28 // st9720 CS -#define LCD_PINS_ENABLE 17 // st9720 DAT - #undef LCD_PINS_D4 #undef LCD_PINS_D5 #undef LCD_PINS_D6 #undef LCD_PINS_D7 +#undef FIL_RUNOUT_PIN +#define LCD_SDSS 31 // Smart Controller SD card reader (rather than the Melzi) +#define LCD_PINS_RS 28 // st9720 CS +#define LCD_PINS_ENABLE 17 // st9720 DAT #define LCD_PINS_D4 30 // st9720 CLK +#define LCD_PINS_D5 -1 +#define LCD_PINS_D6 -1 +#define LCD_PINS_D7 -1 +#define FIL_RUNOUT_PIN -1 // Uses Beeper/LED Pin Pulled to GND + +// Alter timing for graphical display +#define ST7920_DELAY_1 DELAY_2_NOP +#define ST7920_DELAY_2 DELAY_2_NOP +#define ST7920_DELAY_3 DELAY_2_NOP /** PIN: 0 Port: B0 E0_DIR_PIN protected