From b15902d3b5131d1ddfc4d52ce99a54827ece5d53 Mon Sep 17 00:00:00 2001 From: Erik van der Zalm Date: Fri, 18 Nov 2011 19:46:16 +0100 Subject: [PATCH] Fixed bug in configuration.h --- Marlin/Configuration.h | 16 ++++++++-------- 1 file changed, 8 insertions(+), 8 deletions(-) diff --git a/Marlin/Configuration.h b/Marlin/Configuration.h index cf38cea36..9bcddc872 100644 --- a/Marlin/Configuration.h +++ b/Marlin/Configuration.h @@ -31,7 +31,7 @@ // Sanguinololu 1.2 and above = 62 // Ultimaker = 7, // Teensylu = 8 -#define MOTHERBOARD 5 +#define MOTHERBOARD 7 //=========================================================================== //=============================Thermal Settings ============================ @@ -176,10 +176,10 @@ const bool ENDSTOPS_INVERTING = true; // set to true to invert the logic of the //#define INVERT_Z_DIR false // for Mendel set to false, for Orca set to true //#define INVERT_E_DIR true // for direct drive extruder v9 set to true, for geared extruder set to false -//#define INVERT_X_DIR true // for Mendel set to false, for Orca set to true -//#define INVERT_Y_DIR false // for Mendel set to true, for Orca set to false -//#define INVERT_Z_DIR true // for Mendel set to false, for Orca set to true -//#define INVERT_E_DIR false // for direct drive extruder v9 set to true, for geared extruder set to false +#define INVERT_X_DIR true // for Mendel set to false, for Orca set to true +#define INVERT_Y_DIR false // for Mendel set to true, for Orca set to false +#define INVERT_Z_DIR true // for Mendel set to false, for Orca set to true +#define INVERT_E_DIR false // for direct drive extruder v9 set to true, for geared extruder set to false //// ENDSTOP SETTINGS: // Sets direction of endstops when homing; 1=MAX, -1=MIN @@ -242,11 +242,11 @@ const bool ENDSTOPS_INVERTING = true; // set to true to invert the logic of the // The watchdog waits for the watchperiod in milliseconds whenever an M104 or M109 increases the target temperature // this enables the watchdog interrupt. //#define USE_WATCHDOG -#ifdef USE_WATCHDOG +//#ifdef USE_WATCHDOG // you cannot reboot on a mega2560 due to a bug in he bootloader. Hence, you have to reset manually, and this is done hereby: //#define RESET_MANUAL //#define WATCHDOG_TIMEOUT 4 //seconds - +//#endif // extruder advance constant (s2/mm3) // @@ -272,7 +272,7 @@ const bool ENDSTOPS_INVERTING = true; // set to true to invert the logic of the //#define ULTRA_LCD //general lcd support, also 16x2 //#define SDSUPPORT // Enable SD Card Support in Hardware Console -//#define ULTIPANEL +#define ULTIPANEL #ifdef ULTIPANEL // #define NEWPANEL //enable this if you have a click-encoder panel #define SDSUPPORT