M404 should not use 'N' address as parameter because 'N' is reserved for the line number

master
Greg Alexander 10 years ago
parent 9dccd3a94f
commit ed7874b4e0

@ -3861,11 +3861,11 @@ inline void gcode_M400() { st_synchronize(); }
#ifdef FILAMENT_SENSOR
/**
* M404: Display or set the nominal filament width (3mm, 1.75mm ) N<3.0>
* M404: Display or set the nominal filament width (3mm, 1.75mm ) W<3.0>
*/
inline void gcode_M404() {
#if FILWIDTH_PIN > -1
if (code_seen('N')) {
if (code_seen('W')) {
filament_width_nominal = code_value();
}
else {

Loading…
Cancel
Save