- Disabled autostart of print job to give Cura more control.
- Start GCODE will need to be modified to add M75
- End GCODE will need to be modified to add M77
- Added ability in Marlin to execute GCODE macros immediately.
- Reimplemented the G29 functionality for Hibiscus.
- Should no longer cause out-of-order execution of start GCODE lines.
- Properly issues an "ok" so that Cura does not get hung up.
- Added status messages during a probe fail recovery.
- Made the experimental extended probe recovery code exclusive to Hibiscus.
- Restored the older and proven probing code for other printers.
- When REPROBE_EXTENDED_RECOVERY is enabled, Will now turn off bed
leveling prior to G29 to allow for detection of a failed probe on
the first washer.
- On Hibiscus, a missed probe will trigger the following recovery sequence:
- Rehome
- X axis leveling
- Reprobe (from 1st point).
- On other printers, this FW will revert the old behavior of probing from
the 1st point after a rewipe (rather than continuing from where it failed).
- Fixed issue where temp updates stops updating in status screen.
- Added feedrate controls.
- Added tune print menu.
- Added ability to extrude/retract from touch UI
- Added support for M300 gcode.
- Fixed glitches with the sound code.
- Added USB drive code.
- Note: This is pending the relicensing of the USB code from "GPL v2" to "GPL v2 and later"
which the authors have agreed upon.
- Added ability to browse directory hierarchy.
- Removed Trinamic debug code (this has been superceeded by M122)
- Removed obsolete backlash compensation code
- Removed patch for LCD pause which was fixed upstream.
- Small fix to M914 where negative values were reported incorrectly.
- The B&W LCD will now support scrolling of long status messages
- The B&W LCD code was improved to be more efficient
- The Color LCD code now allows you to touch the temperatures to go into the temp tuning screens
or the positions to go into the move axis screen.
This fix will prevent the printer from halting if the push button
on the LCD is depressed. Since this button is inaccessible on our
printers, it is better to disable it.
- Homing now required before moving any axis.
- Software endstops now enabled to prevent crashing axes.
- Z motors now enabled at startup to hold Z axis.
- Controller fan now runs at 1/2 power at startup.
- Enabled LIN_ADVANCE with Z factor = 0 so that this can be set by a user.
- Disabled LED support on X MAX out of concern that a user may accidently short out their board.
- Re-enabled the Z offset graphics overlay that was pushed to upstream Marlin by us.
- Restored the look of the arrows since upstream decided to change it and introduced some missed pixels in the process.
Marcio Teixeira