/* * Marlin 3D Printer Firmware * Copyright (C) 2016 MarlinFirmware [https://github.com/MarlinFirmware/Marlin] * * Based on Sprinter and grbl. * Copyright (C) 2011 Camiel Gubbels / Erik van der Zalm * * This program is free software: you can redistribute it and/or modify * it under the terms of the GNU General Public License as published by * the Free Software Foundation, either version 3 of the License, or * (at your option) any later version. * * This program is distributed in the hope that it will be useful, * but WITHOUT ANY WARRANTY; without even the implied warranty of * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the * GNU General Public License for more details. * * You should have received a copy of the GNU General Public License * along with this program. If not, see . * */ /** * Minitronics v1.0/1.1 pin assignments */ #ifndef __AVR_ATmega1281__ #error Oops! Make sure you have 'Minitronics' selected from the 'Tools -> Boards' menu. #endif #define LARGE_FLASH true #define X_STEP_PIN 48 #define X_DIR_PIN 47 #define X_ENABLE_PIN 49 #define X_MIN_PIN 5 #define X_MAX_PIN 2 #define Y_STEP_PIN 39 // A6 #define Y_DIR_PIN 40 // A0 #define Y_ENABLE_PIN 38 #define Y_MIN_PIN 2 #define Y_MAX_PIN 15 #define Z_STEP_PIN 42 // A2 #define Z_DIR_PIN 43 // A6 #define Z_ENABLE_PIN 41 // A1 #define Z_MIN_PIN 6 #define Z_MAX_PIN -1 #define E0_STEP_PIN 45 #define E0_DIR_PIN 44 #define E0_ENABLE_PIN 27 #define E1_STEP_PIN 36 #define E1_DIR_PIN 35 #define E1_ENABLE_PIN 37 #define E2_STEP_PIN -1 #define E2_DIR_PIN -1 #define E2_ENABLE_PIN -1 #define SDPOWER -1 #define SDSS 16 #define LED_PIN 46 #define FAN_PIN 9 #define FAN2_PIN -1 #define PS_ON_PIN -1 #define KILL_PIN -1 #define HEATER_0_PIN 7 // EXTRUDER 1 #define HEATER_1_PIN 8 // EXTRUDER 2 #define HEATER_2_PIN -1 #define TEMP_0_PIN 7 // ANALOG NUMBERING #define TEMP_1_PIN 6 // ANALOG NUMBERING #define TEMP_2_PIN -1 // ANALOG NUMBERING #define HEATER_BED_PIN 3 // BED #define TEMP_BED_PIN 6 // ANALOG NUMBERING #define BEEPER_PIN -1 #define LCD_PINS_RS -1 #define LCD_PINS_ENABLE -1 #define LCD_PINS_D4 -1 #define LCD_PINS_D5 -1 #define LCD_PINS_D6 -1 #define LCD_PINS_D7 -1 // Buttons are directly attached using keypad #define BTN_EN1 -1 #define BTN_EN2 -1 #define BTN_ENC -1 // the click #define BLEN_C 2 #define BLEN_B 1 #define BLEN_A 0 #define SD_DETECT_PIN -1 // Minitronics doesn't use this