/** * Marlin 3D Printer Firmware * Copyright (C) 2016 MarlinFirmware [https://github.com/MarlinFirmware/Marlin] * * Based on Sprinter and grbl. * Copyright (C) 2011 Camiel Gubbels / Erik van der Zalm * * This program is free software: you can redistribute it and/or modify * it under the terms of the GNU General Public License as published by * the Free Software Foundation, either version 3 of the License, or * (at your option) any later version. * * This program is distributed in the hope that it will be useful, * but WITHOUT ANY WARRANTY; without even the implied warranty of * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the * GNU General Public License for more details. * * You should have received a copy of the GNU General Public License * along with this program. If not, see . * */ /** * AZTEEG_X3 Arduino Mega with RAMPS v1.4 pin assignments */ #if HOTENDS > 2 || E_STEPPERS > 2 #error "Azteeg X3 supports up to 2 hotends / E-steppers. Comment out this line to continue." #endif #define BOARD_NAME "Azteeg X3" #include "pins_RAMPS_13.h" // // Servos // #undef SERVO0_PIN #undef SERVO1_PIN #define SERVO0_PIN 44 // SERVO1 port #define SERVO1_PIN 55 // SERVO2 port // // LCD / Controller // #if ENABLED(VIKI2) || ENABLED(miniVIKI) #undef DOGLCD_A0 #undef DOGLCD_CS #undef BTN_ENC #define DOGLCD_A0 31 #define DOGLCD_CS 32 #define BTN_ENC 12 #undef STAT_LED_RED_PIN #undef STAT_LED_BLUE_PIN #define STAT_LED_RED_PIN 64 #define STAT_LED_BLUE_PIN 63 #else #define STAT_LED_RED_PIN 6 #define STAT_LED_BLUE_PIN 11 #endif