Marlin Firmware for a JTech Photonics Laser on a LulzBot TAZ 3D Printer https://www.forksand.com
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.

1.0 KiB

Experimental LulzBot Marlin 1.1.4 firmware

This is an experimental development branch of Marlin 1.1.4 for LulzBot printers.

The source on this branch can compile firmware for the TAZ 6 and Mini, as well as all the current toolheads. This firmware also supports some internal R&D prototypes and toolheads.

Safety and warnings:

This is alpha level software. It has not been extensively tested and may damage your printer and present other hazards. Use at your own risk. Do not operate your printer while unattended and be sure to power it off when leaving the room. Please consult the documentation that came with your printer for additional safety and warning information.

Compilation from the command line on Linux using "avr-gcc"

Run the "build-lulzbot-firmware.sh" from the top level directory.

Compilation using Arduino IDE

To select what firmware to build, modify lines 38 and 39 of "Configuration_LulzBot.h" according to the instructions.

Known Issues:

  1. Printer needs to be power cycled to clear "clean nozzle" state.