You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
Scott Lahteine 2610b8d047
Enable thermal runaway protection by default
10 years ago
..
Configuration.h Enable thermal runaway protection by default 10 years ago
Configuration_DUAL.h Enable thermal runaway protection by default 10 years ago
Configuration_adv.h Merge branch 'Development' into eeprom_in_gcode 10 years ago
README.md Fixed path typos in README 10 years ago

README.md

Felix 2.0/3.0 Configuration for Marlin Firmware

Bringing silky smooth prints to Felix.

Build HOWTO

cd Marlin/Marlin
cp example_configurations/Felix/Configuration_adv.h .

The next step depends on your setup:

Single Extruder Configuration

cp example_configurations/Felix/Configuration.h .

Dual Extruder Configuration

cp example_configurations/Felix/Configuration_DUAL.h Configuration.h

Compile Firmware

  • Start the Arduino IDE.
  • Select Tools -> Board -> Arduino Mega 2560
  • Select the correct serial port in Tools -> Serial Port (usually /dev/ttyUSB0)
  • Open Marlin.pde or .ino
  • Click the Verify/Compile button

Flash Firmware

Connected directly via USB

  • Click the Upload button. If all goes well the firmware is uploading

Remote update

Find the latest Arduino build:

ls -altr /tmp/
drwxr-xr-x 5 chrono users 12288 Mar 3 21:41 build6072035599686630843.tmp

Copy the firmware to your printer host:

scp /tmp/build6072035599686630843.tmp/Marlin.cpp.hex a.b.c.d:/tmp/

Connect to your printer host via ssh, stop Octoprint or any other service that may block your USB device and make sure you have avrdude installed, then run:

avrdude -C/etc/avrdude.conf -v -v -v -patmega2560 -cwiring -P/dev/ttyUSB0 \
-b115200 -D -Uflash:w:/tmp/Marlin.cpp.hex:i

Acknowledgements

Mashed together and tested on https://apollo.open-resource.org/mission:resources:picoprint based on collaborative teamwork of @andrewsil1 and @thinkyhead.