Fix location of where the make command should be run

keyboards/lets_split/readme.md

@@ -106,7 +106,7 @@ Notes on Software Configuration
 -------------------------------
 
 Configuring the firmware is similar to any other QMK project. One thing
-to note is that `MATIX_ROWS` in `config.h` is the total number of rows between
+to note is that `MATRIX_ROWS` in `config.h` is the total number of rows between
 the two halves, i.e. if your split keyboard has 4 rows in each half, then
 `MATRIX_ROWS=8`.
 
@@ -115,7 +115,7 @@ not be very difficult to adapt it to support more if required.
 
 Flashing
 -------
-From the keymap directory run `make SUBPROJECT-KEYMAP-avrdude` for automatic serial port resolution and flashing.
+From the `lets_split` directory run `make SUBPROJECT-KEYMAP-avrdude` for automatic serial port resolution and flashing.
 Example: `make rev2-default-avrdude`
 
 

keyboards/minidox/readme.md

@@ -1,7 +1,7 @@
 MiniDox
 =====
 
-![MimiDox](http://i.imgur.com/iWb3yO0.jpg)
+![MiniDox](http://i.imgur.com/iWb3yO0.jpg)
 
 A compact version of the ErgoDox
 
@@ -22,7 +22,7 @@ Flashing
 -------
 Note: Most of this is copied from the Let's Split readme, because it is awesome
 
-From the keymap directory run `make SUBPROJECT-KEYMAP-avrdude` for automatic serial port resolution and flashing.
+From the `minidox` directory run `make SUBPROJECT-KEYMAP-avrdude` for automatic serial port resolution and flashing.
 Example: `make rev1-default-avrdude`
 
 Choosing which board to plug the USB cable into (choosing Master)

keyboards/nyquist/readme.md

@@ -6,6 +6,8 @@ The Nyquist is a 60% split ortholinear board by [Keebio](https://keeb.io). It ha
 
 ## Build Guide
 
+A build log of the Nyquist can be found here: [Nyquist Build Log](http://imgur.com/a/dD4sX).
+
 Since the design is very similar to the Let's Split v2, the build guide for that can be used while the build guide for the Nyquist is being fully developed. A build guide for putting together the Let's Split v2 can be found here: [An Overly Verbose Guide to Building a Let's Split Keyboard](https://github.com/nicinabox/lets-split-guide)
 
 There is additional information there about flashing and adding RGB underglow.
@@ -98,7 +100,7 @@ unnecessary in simple use cases.
 
 Flashing
 -------
-From the keymap directory run `make SUBPROJECT-KEYMAP-avrdude` for automatic serial port resolution and flashing.
+From the `nyquist` directory run `make SUBPROJECT-KEYMAP-avrdude` for automatic serial port resolution and flashing.
 Example: `make rev1-serial-avrdude`
 
 

keyboards/orthodox/readme.md

@@ -96,7 +96,7 @@ the two halves, i.e. if your split keyboard has 3 rows in each half, then
 
 Flashing
 -------
-From the keymap directory run `make SUBPROJECT-KEYMAP-avrdude` for automatic serial port resolution and flashing.
+From the `orthodox` directory run `make SUBPROJECT-KEYMAP-avrdude` for automatic serial port resolution and flashing.
 Example: `make rev2-default-avrdude`