@ -13,6 +14,80 @@ Hardware Availability: [PCB & Case Data](https://github.com/foostan/crkbd)
Make example for this keyboard (after setting up your build environment):
make crkbd:default
```sh
make crkbd:default
```
See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
## RGB Matrix
The Corne Keyboard also supports using the RGB Matrix feature, in place of RGB Light. This provids a better experience when using the keyboard, as it supports a number of per key effects properly. If you're not using the in switch LEDs, then you may want to pass on doing this.
In your keymap's `rules.mk` file, add the following:
```make
RGBLIGHT_ENABLE = no
RGB_MATRIX_ENABLE = WS2812
```
And in your `config.h` file, add the following:
```c
#ifdef RGB_MATRIX_ENABLE
# define RGB_MATRIX_KEYPRESSES // reacts to keypresses
// # define RGB_MATRIX_KEYRELEASES // reacts to keyreleases (instead of keypresses)
// # define RGB_DISABLE_AFTER_TIMEOUT 0 // number of ticks to wait until disabling effects
# define RGB_DISABLE_WHEN_USB_SUSPENDED true // turn off effects when suspended
# define RGB_MATRIX_FRAMEBUFFER_EFFECTS
// # define RGB_MATRIX_LED_PROCESS_LIMIT (DRIVER_LED_TOTAL + 4) / 5 // limits the number of LEDs to process in an animation per task run (increases keyboard responsiveness)
// # define RGB_MATRIX_LED_FLUSH_LIMIT 16 // limits in milliseconds how frequently an animation will update the LEDs. 16 (16ms) is equivalent to limiting to 60fps (increases keyboard responsiveness)
# define RGB_MATRIX_MAXIMUM_BRIGHTNESS 150 // limits maximum brightness of LEDs to 150 out of 255. Higher may cause the controller to crash.
# define RGB_MATRIX_HUE_STEP 8
# define RGB_MATRIX_SAT_STEP 8
# define RGB_MATRIX_VAL_STEP 8
# define RGB_MATRIX_SPD_STEP 10
/* Disable the animations you don't want/need. You will need to disable a good number of these *
* because they take up a lot of space. Disable until you can successfully compile your firmware. */
However, to properly handle the LED matrix, two LED maps had to be used. One for the left half, and one for the right half. For the left, you don't need to do anything. That's the default setup. But for the right side, you need to add `RGB_MATRIX_SPLIT_RIGHT=yes` needs to be added to the command.
First, compile and flash the left half. Then when that's done, recompile with the setting above. It should look something like:
```sh
make crkbd:default RGB_MATRIX_SPLIT_RIGHT=yes
```
And then flash this new firmware image.
After this is done, you should be able to use the normal RGB keycodes, but you'll see the RGB Matrix effects in use, giving a much better experience.
Drashna Jaelre
5 years ago
committed by