pull/1190/head
Osamu Aoki 8 years ago
parent b441468795
commit caab4d7e45

@ -6,12 +6,12 @@ QMK is based on TMK. Understanding the essential changes made should help you
## TMK vs. QMK
| Firmware |TMK |QMK |
|-------------------------------------------------|-----------------------|-------------------------|
| Maintainer |hasu |Jack Humbert et al. |
| Build path customization | `TMK_DIR = ...` | `include .../Makefile` |
| `keymaps` data | 3D array of `uint8_t` holding **keycode** | 3D array of `uint16_t` holding **action code** |
| `fn_actions` data | 1D array of `uint16_t` holding **action code** | 3D array of `uint16_t` holding **action code** |
| Firmware |TMK |QMK |
|---------------------------|-----------------------|-------------------------|
| Maintainer |hasu |Jack Humbert et al. |
| Build path customization | `TMK_DIR = ...` | `include .../Makefile` |
| `keymaps` data | 3D array of `uint8_t` holding **keycode** | 3D array of `uint16_t` holding **action code** |
| `fn_actions` data | 1D array of `uint16_t` holding **action code** | 1D array of `uint16_t` holding **action code** |
Since QMK is based on TMK and uses major portion of TMK code as is, understanding the essential changes made should help you understand the code.
@ -45,7 +45,7 @@ Keymap layer has its state in two 32 bit parameters:
* **`default_layer_state`** indicates a base keymap layer(0-31) which is always valid and to be referred.
* **`layer_state`** () has current on/off status of the layer on its each bit.
Keymap has its state in two parameter**`default_layer`** indicates a base keymap layer(0-31) which is always valid and to be referred, **`keymap_stat`** is 16bit variable which has current on/off status of layers on its each bit.
Keymap has its state in two parameter **`default_layer`** indicates a base keymap layer(0-31) which is always valid and to be referred, **`keymap_stat`** is 16bit variable which has current on/off status of layers on its each bit.
Keymap layer '0' is usually `default_layer` and which is the only valid layer and other layers is initially off after boot up firmware, though, you can configured them in `config.h`.
To change `default_layer` will be useful when you switch key layout completely, say you want Colmak instead of Qwerty.

Loading…
Cancel
Save