forksand
/
qmk_firmware
1
0
Fork 0
Code Issues Pull Requests Releases Wiki Activity
519 Commits
79 Branches
743 Tags
226 MiB
Branches Tags
${ item.name }
Create tag ${ searchTerm }
Create branch ${ searchTerm }
from '33a46b243a'
${ noResults }
Commit Graph

31 Commits (33a46b243a0f204f3ade095f7b213d9d2598c450)

Author SHA1 Message Date
Dean Camera 33a46b243a PDI NVM enable is fast enough that bare polling is enough without a fixed delay in between each attempt. Make sure the USART transmitter is enabled explicitly when the USART is configured, so that repeated attempts to re-enter PDI mode don't fail due to TXEN not being set.
15 years ago
Dean Camera 66201a05e9 Fix PDI code - must send NVM enable key least significant byte first, need to make sure Tx and Rx is switched correctly including disabling the output on the Tx line when receiving.
15 years ago
Dean Camera 7e5966c1a8 Fix AVRISP PDI protocol - make sure inverted masks have the appropriate parenthesis around them, make sure the BREAK command for the hardware USART has 12 clock cycles exactly. Poll NVM Enable bit in the target's STATUS PDI register with a timeout, as it is not set immediately.
15 years ago
Dean Camera 42cfd15793 Change over AVRISP project to have both hardware USART and software USART modes for the PDI protocol, when enabled. Fix up PDI initialisation routines.
15 years ago
Dean Camera 7aecda6fda Fix PDITarget_ReceiveByte() not discarding the start bit properly, and reading in the bits inverted and in the wrong order.
15 years ago
Dean Camera 1e3513ed70 Add even parity bit to the software USART framing in the AVRISP project's PDI programming code.
15 years ago
Dean Camera 9c8ed168e5 Fix inverted bit-banged USART logic in the AVRISP project for PDI programming. Add a delay to the clock toggling in the AVRISP project to ensure that the programming speed does not exceed 10MHz under any conditions to satisfy the limits in the datasheet for all target voltages. Fix incorrect pin being used as the DATA in in PDI programming mode.
15 years ago
Dean Camera 7ace314cc1 Increase timeout of Mass Storage and Still Image host commands to 10 seconds (up from 5) to account for slow-processing devices.
15 years ago
Dean Camera 2281750b5f Make sure that USB_STREAM_TIMEOUT_MS is set in the MassStorageHost ClassDriver demo, so that slow devices don't time out the data pipe. Increase pipe timeout in both MassStorageHost demos to 5 seconds to account for the really slow devices.
15 years ago
Dean Camera 2919aeeaab Fixed HID Parser not distributing the Usage Min and Usage Max values across an array of report items.
15 years ago
Dean Camera f338ddcb87 Make sure the protocol handler files are included in the Doxygen documentation of the AVRISP project.
15 years ago
Dean Camera 258a6a0177 Fix the tokens which enable and disable the different programming protocols in the AVRISP project.
15 years ago
Dean Camera f1baf12fae Auto-configure AVRISP programmer configuration when built for the XPLAIN board to match the XPLAIN hardware connections.
15 years ago
Dean Camera a5adbae652 Document the PDI programming routines implemented so far in the AVRISP project. Add ability to selectively disable ISP programming support in addition to the existing ability to disable PDI programming support.
15 years ago
Dean Camera f69f03cb0d Started implementing the low level PDI protocol in the AVRISP project, for XMEGA device programming.
15 years ago
Dean Camera 1f8dfd0205 Add support for unwrapping of the XMEGA PDI programming protocol to the AVRISP Programmer project.
15 years ago
Dean Camera 5930f47bf4 Rename V2ProtocolTarget files to ISPTarget in the AVRISP Programmer Clone project.
15 years ago
Dean Camera 1ed6925b5b Factor out all the ISP related code into a seperate ISPProtocol set of files in the AVRISP Clone programmer project, to clearly seperate out the programming protocols when PDI programming is implemented.
15 years ago
Dean Camera 1645c3d243 Rename the V2Protocol command handlers in the AVRISP project in preperation of XMEGA PDI programming support.
15 years ago
Dean Camera d6edfe35c8 Spell check all source code variables, comments and strings.
15 years ago
Dean Camera c647c27639 Minor changes to the AVRISP project for code clarity.
15 years ago
Dean Camera 409c49f057 Doxygen fixes to \param directives to give data direction in all projects. Make HID item filtering routines clearer in the HID WithParser demos.
15 years ago
Dean Camera 244c86429b Move ADC VTARGET sampling to a new V2Params_UpdateParamValues() in the AVRISP project so that there is a central place where all non-PC set target values can be updated easily.
15 years ago
Dean Camera 4bb236e9a0 Increase AVRISP command timeout to 240ms up from 150ms to prevent some ISP commands from timing out too early.
15 years ago
Dean Camera 489515fbbf Make WaitWhileBusy function in the AVRISP project more explicit about how it sends and receives the busy check command.
15 years ago
Dean Camera 922e60192d Condensed SCSI command functions in the LowLevel Mass Storage Host demo, to save on FLASH space.
15 years ago
Dean Camera 244bba2097 Make AVRISP project build again - fix incorrect preprocessor directive in V2Protocol.c, fix makefile LUFA_PATH.
15 years ago
Dean Camera 271be037b7 Partial Commit: Move AVRISP project out of the Projects\Incomplete directory.
15 years ago
Dean Camera 0934f5c185 Move AVRISP Programmer project to a new Unfinished subdirectory of Project while it is under development.
15 years ago
Dean Camera bbcdaaa6dc Enhancements to the AVRISP Programmer project to attempt to get AVRStudio to communicate with the device.
15 years ago
Dean Camera ecd82778cf Added beginnings of a new AVRISP-MKII clone project.
15 years ago