/** \file * * This file contains special DoxyGen information for the generation of the main page and other special * documentation pages. It is not a project source file. */ /** \mainpage AVRISP MKII Programmer Project * * \section SSec_Compat Demo Compatibility: * * The following table indicates what microcontrollers are compatible with this demo. * * - AT90USB1287 * - AT90USB1286 * - AT90USB647 * - AT90USB646 * - ATMEGA32U6 * - ATMEGA32U4 * - ATMEGA16U4 * - AT90USB162 * - AT90USB82 * * \section SSec_Info USB Information: * * The following table gives a rundown of the USB utilization of this demo. * * * * * * * * * * * * * * * * * * * * * * *
USB Mode:Device
USB Class:Vendor Specific Class
USB Subclass:N/A
Relevant Standards:Atmel AVRISP MKII Protocol Specification
Usable Speeds:Full Speed Mode
* * \section SSec_Description Project Description: * * Firmware for an AVRStudio compatible AVRISP-MKII clone programmer. This project will enable the USB AVR series of * microcontrollers to act as a clone of the official Atmel AVRISP-MKII programmer, usable within AVRStudio. In its * most basic form, it allows for the programming of 5V AVRs from within AVRStudio with no special hardware other than * the USB AVR and the parts needed for the USB interface. If the user desires, more advanced circuits incorporating * level conversion can be made to allow for the programming of 3.3V AVR designs. * * This device spoofs Atmel's official AVRISP-MKII device PID so that it remains compatible with Atmel's AVRISP-MKII * drivers. When promted, direct your OS to install Atmel's AVRISP-MKII drivers provided with AVRStudio. * * Note that this design currently has several limitations: * - Minimum target clock speed of 500KHz due to hardware SPI used * - No VTARGET detection and notification * - No reversed/shorted target connector detection and notification * * \section SSec_Options Project Options * * The following defines can be found in this demo, which can control the demo behaviour when defined, or changed in value. * * * * * * * * * * * * * * * * * * * * * * *
Define Name:Location:Description:
RESET_LINE_PORTMakefile CDEFSPORT register for the programmer's target RESET line.
RESET_LINE_DDRMakefile CDEFSDDR register for the programmer's target RESET line.
RESET_LINE_MASKMakefile CDEFSMask for the programmer's target RESET line on the chosen port.
*/