/** \file * * This file contains special DoxyGen information for the generation of the main page and other special * documentation pages. It is not a project source file. */ /** \mainpage Mass Storage Host Demo * * \section Sec_Compat Demo Compatibility: * * The following list indicates what microcontrollers are compatible with this demo. * * \li Series 7 USB AVRs (AT90USBxxx7) * * \section Sec_Info USB Information: * * The following table gives a rundown of the USB utilization of this demo. * * <table> * <tr> * <td><b>USB Mode:</b></td> * <td>Host</td> * </tr> * <tr> * <td><b>USB Class:</b></td> * <td>Mass Storage Device</td> * </tr> * <tr> * <td><b>USB Subclass:</b></td> * <td>Bulk Only</td> * </tr> * <tr> * <td><b>Relevant Standards:</b></td> * <td>USBIF Mass Storage Standard \n * USB Bulk-Only Transport Standard \n * SCSI Primary Commands Specification \n * SCSI Block Commands Specification</td> * </tr> * <tr> * <td><b>Supported USB Speeds:</b></td> * <td>Full Speed Mode</td> * </tr> * </table> * * \section Sec_Description Project Description: * * Mass Storage host demonstration application. This gives a simple reference * application for implementing a USB Mass Storage host, for USB storage devices * using the standard Mass Storage USB profile. * * The first 512 bytes (boot sector) of an attached disk's memory will be dumped * out of the serial port in HEX and ASCII form when it is attached to the AT90USB1287 * AVR. The device will then wait for HWB to be pressed, whereupon the entire ASCII contents * of the disk will be dumped to the serial port. * * \section Sec_Options Project Options * * The following defines can be found in this demo, which can control the demo behaviour when defined, or changed in value. * * <table> * <tr> * <td> * None * </td> * </tr> * </table> */