- Implement advanced LED flash support
- Tweak HAL_SPI_TransmitReceive to tolerate a longer SysTick interrupt
- Tune KEYBOARD_BOTDETECT parameters
- L-shift and R-shift are now high-speed alphanumeric keys
(Upstream). Also implemented read-only mass storage mode.
Todo:
- Test. Everything!!!
- Report write protect flag in SCSI "mode parameter header" (whatever
that is)
Upstream's edge-detect interrupt that starts SPI transmission was not
firing. Sometimes. On some boards only. The cause was Downstream not
allowing enough time between edges for Upstream to catch the signal.
Also misc code tidyups.
It turns out that suspend support on the STM32 USB core is buggy as
heck. Host mode cannot resume after suspend, and device mode cannot
receive resume or send wakeup signalling.
I managed to fake resume support by keeping Downstream and our connected
device running at full power, and simulating a wakeup event to the host
by disconnecting/reconnecting Upstream from the host.
...Downstream was not always changing state correctly after closely
spaced interrupts.
Also improve flash-write-lockout function to avoid dependency on
optimisation level.
So apparently the STM32F401's SPI DMA is even more buggy than the 405's.
Worked around an intermittent stall/timeout by busy-waiting Upstream's
packet length transmission and reception, instead of DMA-ing it like the
packet body. Ugh...
correctly now, either because SPI is in 16-bit mode, or because I found
all the other bugs!
Doubled SPI baudrate to 10.5Mbps. Transfer speed now limited (again) by
Downstream's lack of FIFO buffering in the USB host controller.
Also disabled DMA transaction half-complete interrupt in
stm32f4xx_hal_dma.c, as it wasn't doing anything useful.
Robert Fisk