|
|
@ -85,7 +85,7 @@ AutoTemp:
|
|
|
|
If your gcode contains a wide spread of extruder velocities, or you realtime change the building speed, the temperature should be changed accordingly.
|
|
|
|
If your gcode contains a wide spread of extruder velocities, or you realtime change the building speed, the temperature should be changed accordingly.
|
|
|
|
Usually, higher speed requires higher temperature.
|
|
|
|
Usually, higher speed requires higher temperature.
|
|
|
|
This can now be performed by the AutoTemp function
|
|
|
|
This can now be performed by the AutoTemp function
|
|
|
|
By calling M109 S<mintemp> T<maxtemp> F<factor> you enter the autotemp mode.
|
|
|
|
By calling M109 S<mintemp> B<maxtemp> F<factor> you enter the autotemp mode.
|
|
|
|
|
|
|
|
|
|
|
|
You can leave it by calling M109 without any F.
|
|
|
|
You can leave it by calling M109 without any F.
|
|
|
|
If active, the maximal extruder stepper rate of all buffered moves will be calculated, and named "maxerate" [steps/sec].
|
|
|
|
If active, the maximal extruder stepper rate of all buffered moves will be calculated, and named "maxerate" [steps/sec].
|
|
|
|