Fix up configs a little

master
Scott Lahteine 10 years ago
parent 8309b4f408
commit 84a87a5b1c

@ -344,17 +344,15 @@ const bool Z_MAX_ENDSTOP_INVERTING = true; // set to true to invert the logic of
#define DISABLE_MAX_ENDSTOPS
#endif
// @section homing
// @section machine
// For Inverting Stepper Enable Pins (Active Low) use 0, Non Inverting (Active High) use 1
// :[0,1]
// :{0:'Active Low',1:'Active High'}
#define X_ENABLE_ON 0
#define Y_ENABLE_ON 0
#define Z_ENABLE_ON 0
#define E_ENABLE_ON 0 // For all extruders
// @section machine
// Disables axis when it's not being used.
#define DISABLE_X false
#define DISABLE_Y false
@ -367,15 +365,18 @@ const bool Z_MAX_ENDSTOP_INVERTING = true; // set to true to invert the logic of
// @section machine
#define INVERT_X_DIR true // for Mendel set to false, for Orca set to true
#define INVERT_Y_DIR false // for Mendel set to true, for Orca set to false
#define INVERT_Z_DIR true // for Mendel set to false, for Orca set to true
// Invert the stepper direction. Change (or reverse the motor connector) if an axis goes the wrong way.
#define INVERT_X_DIR true // Mendel: false
#define INVERT_Y_DIR false // Mendel: true
#define INVERT_Z_DIR true // Mendel: false
// @section extruder
#define INVERT_E0_DIR false // for direct drive extruder v9 set to true, for geared extruder set to false
#define INVERT_E1_DIR false // for direct drive extruder v9 set to true, for geared extruder set to false
#define INVERT_E2_DIR false // for direct drive extruder v9 set to true, for geared extruder set to false
// For direct drive extruder v9 set to true, for geared extruder set to false.
#define INVERT_E0_DIR false
#define INVERT_E1_DIR false
#define INVERT_E2_DIR false
#define INVERT_E3_DIR false
// @section homing

@ -95,7 +95,7 @@
//=============================Mechanical Settings===========================
//===========================================================================
// @section machine
// @section homing
#define ENDSTOPS_ONLY_FOR_HOMING // If defined the endstops will only be used for homing
@ -146,6 +146,7 @@
#endif //End auto min/max positions
//END AUTOSET LOCATIONS OF LIMIT SWITCHES -ZP
// @section extras
//#define Z_LATE_ENABLE // Enable Z the last moment. Needed if your Z driver overheats.

Loading…
Cancel
Save