Don't include Z_RAISE_AFTER_PROBING if not used (PR#2527)

Marlin/Marlin_main.cpp

@@ -1425,8 +1425,11 @@ static void setup_for_endstop_move() {
 
       // Move up for safety
       feedrate = Z_PROBE_ALLEN_KEY_STOW_1_FEEDRATE;
+
+      #if Z_RAISE_AFTER_PROBING > 0
         destination[Z_AXIS] = current_position[Z_AXIS] + Z_RAISE_AFTER_PROBING;
         prepare_move_raw(); // this will also set_current_to_destination
+      #endif
 
       // Move to the start position to initiate retraction
       destination[X_AXIS] = Z_PROBE_ALLEN_KEY_STOW_1_X;
@@ -1610,7 +1613,9 @@ static void setup_for_endstop_move() {
 
     float oldXpos = current_position[X_AXIS]; // save x position
     if (dock) {
+      #if Z_RAISE_AFTER_PROBING > 0
         do_blocking_move_to_z(current_position[Z_AXIS] + Z_RAISE_AFTER_PROBING); // raise Z
+      #endif
       do_blocking_move_to_x(X_MAX_POS + SLED_DOCKING_OFFSET + offset - 1);  // Dock sled a bit closer to ensure proper capturing
       digitalWrite(SLED_PIN, LOW); // turn off magnet
     } else {
@@ -2766,7 +2771,11 @@ inline void gcode_G28() {
         //      adjust for inaccurate endstops, not for reasonably accurate probes. If it were
         //      added here, it could be seen as a compensating factor for the Z probe.
         //
-        current_position[Z_AXIS] = -zprobe_zoffset + Z_RAISE_AFTER_PROBING + (z_tmp - real_z);
+        current_position[Z_AXIS] = -zprobe_zoffset + (z_tmp - real_z)
+          #if ENABLED(SERVO_ENDSTOPS) || ENABLED(Z_PROBE_ALLEN_KEY) || ENABLED(Z_PROBE_SLED)
+             + Z_RAISE_AFTER_PROBING
+          #endif
+          ;
         // current_position[Z_AXIS] += home_offset[Z_AXIS]; // The probe determines Z=0, not "Z home"
         sync_plan_position();
       }