Follow-up the PR #4065 (Remove support for XY servo endstops)
master
Scott Lahteine 9 years ago committed by GitHub
commit e35583888c

@ -419,7 +419,7 @@ const bool Z_MIN_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the l
// To use a separate Z probe, your board must define a Z_MIN_PROBE_PIN. // To use a separate Z probe, your board must define a Z_MIN_PROBE_PIN.
// //
// For a servo-based Z probe, you must set up servo support below, including // For a servo-based Z probe, you must set up servo support below, including
// NUM_SERVOS, Z_ENDSTOP_SERVO_NR and SERVO_ENDSTOP_ANGLES. // NUM_SERVOS, Z_ENDSTOP_SERVO_NR and Z_SERVO_ANGLES.
// //
// - RAMPS 1.3/1.4 boards may be able to use the 5V, GND, and Aux4->D32 pin. // - RAMPS 1.3/1.4 boards may be able to use the 5V, GND, and Aux4->D32 pin.
// - Use 5V for powered (usu. inductive) sensors. // - Use 5V for powered (usu. inductive) sensors.
@ -1155,10 +1155,8 @@ const bool Z_MIN_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the l
// This allows for servo actuated endstops, primary usage is for the Z Axis to eliminate calibration or bed height changes. // This allows for servo actuated endstops, primary usage is for the Z Axis to eliminate calibration or bed height changes.
// Use M851 to set the Z probe vertical offset from the nozzle. Store that setting with M500. // Use M851 to set the Z probe vertical offset from the nozzle. Store that setting with M500.
// //
//#define X_ENDSTOP_SERVO_NR 1
//#define Y_ENDSTOP_SERVO_NR 2
//#define Z_ENDSTOP_SERVO_NR 0 //#define Z_ENDSTOP_SERVO_NR 0
//#define SERVO_ENDSTOP_ANGLES {{0,0}, {0,0}, {70,0}} // X,Y,Z Axis Extend and Retract angles //#define Z_SERVO_ANGLES {70,0} // Z Servo Extend and Retract angles
// Servo deactivation // Servo deactivation
// //

Loading…
Cancel
Save