Update planner.h

Changed level and leveling to compensation.
master
John Davis 10 years ago
parent ac204028e7
commit e99f24ff2f

@ -26,9 +26,9 @@
#include "Marlin.h" #include "Marlin.h"
#ifdef ENABLE_AUTO_BED_LEVELING #ifdef ENABLE_AUTO_BED_COMPENSATION
#include "vector_3.h" #include "vector_3.h"
#endif // ENABLE_AUTO_BED_LEVELING #endif // ENABLE_AUTO_BED_COMPENSATION
// This struct is used when buffering the setup for each linear movement "nominal" values are as specified in // This struct is used when buffering the setup for each linear movement "nominal" values are as specified in
// the source g-code and may never actually be reached if acceleration management is active. // the source g-code and may never actually be reached if acceleration management is active.
@ -71,10 +71,10 @@ typedef struct {
volatile char busy; volatile char busy;
} block_t; } block_t;
#ifdef ENABLE_AUTO_BED_LEVELING #ifdef ENABLE_AUTO_BED_COMPENSATION
// this holds the required transform to compensate for bed level // this holds the required transform to compensate for bed compensation
extern matrix_3x3 plan_bed_level_matrix; extern matrix_3x3 plan_bed_compensation_matrix;
#endif // #ifdef ENABLE_AUTO_BED_LEVELING #endif // #ifdef ENABLE_AUTO_BED_COMPENSATION
// Initialize the motion plan subsystem // Initialize the motion plan subsystem
void plan_init(); void plan_init();
@ -82,21 +82,21 @@ void plan_init();
// Add a new linear movement to the buffer. x, y and z is the signed, absolute target position in // Add a new linear movement to the buffer. x, y and z is the signed, absolute target position in
// millimaters. Feed rate specifies the speed of the motion. // millimaters. Feed rate specifies the speed of the motion.
#ifdef ENABLE_AUTO_BED_LEVELING #ifdef ENABLE_AUTO_BED_COMPENSATION
void plan_buffer_line(float x, float y, float z, const float &e, float feed_rate, const uint8_t &extruder); void plan_buffer_line(float x, float y, float z, const float &e, float feed_rate, const uint8_t &extruder);
// Get the position applying the bed level matrix if enabled // Get the position applying the bed compensation matrix if enabled
vector_3 plan_get_position(); vector_3 plan_get_position();
#else #else
void plan_buffer_line(const float &x, const float &y, const float &z, const float &e, float feed_rate, const uint8_t &extruder); void plan_buffer_line(const float &x, const float &y, const float &z, const float &e, float feed_rate, const uint8_t &extruder);
#endif // ENABLE_AUTO_BED_LEVELING #endif // ENABLE_AUTO_BED_COMPENSATION
// Set position. Used for G92 instructions. // Set position. Used for G92 instructions.
#ifdef ENABLE_AUTO_BED_LEVELING #ifdef ENABLE_AUTO_BED_COMPENSATION
void plan_set_position(float x, float y, float z, const float &e); void plan_set_position(float x, float y, float z, const float &e);
#else #else
void plan_set_position(const float &x, const float &y, const float &z, const float &e); void plan_set_position(const float &x, const float &y, const float &z, const float &e);
#endif // ENABLE_AUTO_BED_LEVELING #endif // ENABLE_AUTO_BED_COMPENSATION
void plan_set_e_position(const float &e); void plan_set_e_position(const float &e);

Loading…
Cancel
Save