* [1.1.x] Fix NO_MOTION_BEFORE_HOMING unwanted behaviour
NO_MOTION_BEFORE_HOMING should prevent XYZ movements only when homing is not done.
E axes should be allowed
* Update Marlin_main.cpp
* Update Marlin_main.cpp
* Update Marlin_main.cpp
* Fixed M303 thermal protection
The temperature sanity checking logic was not being applied during M303
(pid autotuning) because instead of setting a target temperature, it
directly manipulated the pwm values. When PIDTEMP/PIDTEMPBED is
enabled, PWM values rather than the target temperature determine whether
the heater is on. I changed this to look directly at the PWM amount
when pid is enabled.
* Turn off heaters on M303 error
Currently, PID autotuning stops if it overshoots the temperature by 20C
or if if the temperature does not change for 20 minutes and it times
out. I added calls to disable the heaters in these scenarios.
* Removed unnecessary if statement.
Added changes suggested by GMagician.
* Update temperature.cpp
* Update temperature.cpp
* Update temperature.cpp
* Initial conflict resolution
All previous items resolved:
- Use of ELAPSED() on timer code
- Switch to use of defer_return_to_status=true as much as possible
- Update & Clean Up of Max7219 routines
* Resolve non-SD case in ultralcd.cpp
* use reduced sized font for some languages
* Fit Portuguese language files to existing scheme
* Rename language_pl-DOGM.h to language_pl_utf8.h
* Rename language_pl_utf8.h to language_pl-DOGM.h
* Update dogm_font_data_ISO10646_1.h
* Update dogm_font_data_ISO10646_1.h
* Add M290 babystepping
* Allow `Z` for `M290`
* fix spacing
* Support BABYSTEP_XY in M290
* Not just Z
* Extend M290 for BABYSTEP_ZPROBE_OFFSET
* tweak
Scott Lahteine