670413603f
The EEPROM stream read/write functions now use eeprom_update_byte() instead of eeprom_write_byte(), so that only changed bytes are written to EEPROM to preserve its lifespan.
...
Changed over the AVRISP-MKII and TemperatureDataLogger projects to use eeprom_update_byte() when writing non-volatile parameters to EEPROM to preserve its lifespan.
15 years ago
9c037a952f
The RingBuff library code has been replaced in the XPLAINBridge project with an ultra lightweight buffer to help improve the reliability of the bridge.
15 years ago
4a13a5484a
Fixed RNDISEthernet demos crashing when calculating checksums for Ethernet/TCP packets of more than ~500 bytes due to an overflow in the checksum calculation loop (thanks to Kevin Malec).
...
Removed string Attributes from the Service Discovery Protocol code to minimise the potential points of failure while the base code is being debugged.
15 years ago
58a0ee67a3
Oops - when adding a sequence header to the SDP response, the size value needs to be cleared, not the buffer pointer.
15 years ago
d3699d0261
Added new ADC_DisableChannel() function (thanks to Mich Davis).
15 years ago
f13bc35a19
Begin processing code for Service Discovery Protocol attributes.
15 years ago
ff61dfa505
Fixed AVRISP project not sending a full erase-and-write EEPROM command to XMEGA targets when writing to the EEPROM instead of the split write-only command (thanks to Tim Margush).
15 years ago
80d85090ba
Fixed AVRISP project sending a LOAD EXTENDED ADDRESS command to 128KB AVRs after programming or reading from the last page of FLASH.
15 years ago
6b7770ef2b
Commit for 100513 re-release due to critical device mode bug.
15 years ago
34047efc7e
Remove incorrect check for the current device state in the Set Configuration request handler of DevChapter9, which broke Set Configuration requests to the device under most circumstances.
...
Move out the SPI prescaler list to a PROGMEM module-level variable in ISPTarget.c.
15 years ago
571159df1b
Additional fix to the AVRISP-MKII clone project for 256KB AVRs.
15 years ago
cd0093a14b
Fixed AVRISP-MKII clone project not correctly issuing SET EXTENDED ADDRESS commands when the extended address boundary is crossed during programming or readback (thanks to Gerard Sexton).
...
Fixed warnings when building the AVRISP-MKII clone project with the ENABLE_XPROG_PROTOCOL compile time option disabled.
15 years ago
1331cce08a
Fixed possible device lockup when INTERRUPT_CONTROL_ENDPOINT is enabled and the control endpoint is not properly selected when the ISR completes.
15 years ago
d3c623e1e1
The LIBUSB_FILTERDRV_COMPAT compile time option in the XPLAINBridge and AVRISP-MKII projects has been renamed LIBUSB_DRIVER_COMPAT, as it applies to all software on all platforms using the libUSB driver.
...
Fix Benito makefile which was accidentally changed during testing.
15 years ago
e277ff0cf4
Removed TeensyHID bootloader, per request from Paul at PJRC.
15 years ago
3080988b35
Commit for the 100512 release.
15 years ago
05ac59d0ee
Add new ReportType parameter to the HID class driver device callback and host report sending routines.
...
Renamed internal Host mode Class driver descriptor comparator callback routines so that they all start with a uniform DCOMP_{Class Abbreviation}_ prefix.
15 years ago
071e02c6b6
Add svn:eol-style property to source files, so that the line endings are correctly converted to the target system's native end of line style.
15 years ago
a9e0935a90
Device mode class driver callbacks are now fired before the control request status stage is sent to prevent the host from timing out if another request is immediately fired and the device has a lengthy callback routine.
...
Inlined currently unused MIDI ProcessControlRequest routine.
15 years ago
2a2de8fea9
Fix TeensyHID bootloader for the largest AVRs - only the ATMEGA128x needs the alternative addressing scheme.
15 years ago
842e219bf3
Added new EVENT_CDC_Device_BreakSent() event and CDC_Host_SendBreak() function to the Device and Host CDC Class drivers.
15 years ago
9c8bd6ed9b
Remove incorrect Abstract Call Management class specific descriptor from the CDC demos, bootloaders and projects.
15 years ago
c3db72afdc
Make CDC class bootloader hard-reset the AVR when exited instead of a soft-reset. Reduce size of the TeensyHID bootloader slightly.
...
Fix the TeensyHID bootloader for the larger USB AVR devices, since Paul uses a different (undocumented) addressing scheme on these devices.
15 years ago
ab8668b14e
Removed software PDI/TPI emulation from the AVRISP-MKII clone project, as it was very buggy. PDI and TPI must now be implemented via seperate headers instead of the one unified ISP/TPI/PDI header.
15 years ago
708a1c6166
Fixed INTERRUPT_CONTROL_ENDPOINT compile time option preventing other interrupts from occuring while the control endpoint request is being processed, causing possible lockups if a USB interrupt occurs during a transfer.
15 years ago
e652cfac67
Fixed Host mode HID class driver not sending the correct report type when HID_Host_SendReportByID() was called and the HID_HOST_BOOT_PROTOCOL_ONLY compile time option is set.
15 years ago
27f0ba6fc3
Fixed device state not being reset back to the default state if the host sets the address to 0x00.
...
Fixed Set Configuration requests not being stalled until the host has set the device's address.
Fixed possibility of internal signature retrieval being corrupted if an interrupt occurs during a signature byte read (thanks to Andrei Krainev).
15 years ago
eed7d4df6a
Added new ENDPOINT_*_BusSuspended error code to the Endpoint function, so that the stream functions early-abort if the bus is suspended before or during a transfer.
15 years ago
3d28d53c3e
Change AVRISP project's timeout to be interrupt based again, but make the interrupt itself interruptable and use a seperate assembly file to hand-optimize the ISR code.
...
Removed the cast to uint16_t on the set baud rate in the USBtoSerial project, so that the higher >1M baud rates can be selected (thanks to Steffan).
15 years ago
9cad677ebb
The Audio_Device_IsSampleReceived() and Audio_Device_IsReadyForNextSample() functions are now inline, to reduce overhead.
15 years ago
9e34144c9b
Use puts_P() and printf_P() instead of the normal variants where possible in the Host mode Class Driver demos.
15 years ago
e977774d4e
Relocate USBInterrupt.c/.h from the HighLevel USB driver directory to the LowLevel directory as it is hardware-dependent.
15 years ago
59c4871f80
USB_Init() no longer calls sei() to enable global interrupts - this must now be done in the user application once all init code has run.
15 years ago
5993e1efe7
Added ability to search by Channel PSM to the GetChannelData() function in the BluetoothHost demo.
...
Added new HCI states to properly initialize the bluetooth dongle and retrieve the local BDADDR.
Factored out Bluetooth state information into a new state structure for easy reference in the user application.
Added new StackInitialized() Bluetooth stack callback function.
15 years ago
8252b4febd
Fixed HID Device Class Driver not allocating a temporary buffer when the host requests a report via the control endpoint and the user has set the PrevReportINBuffer driver configuration element to NULL (thanks to Lars Noschinski).
...
Clean up incomplete BluetoothHost debugging commands to use GCC extension to avoid NULL parameters when no formatting is required.
15 years ago
d92e9133d3
Make bluetooth SDP code correctly unpack the search UUIDs and parameters.
...
Minor documentation improvements.
15 years ago
1f682ca2de
Minor documentation improvements.
15 years ago
3eb81df998
Rename FunctionAttributes.h to Attributes.h, as some attributes are applicable to variables also. Add new ATTR_NOINIT attribute for global variables.
...
Add the beginnings of a SDP implentation to the incomplete BluetoothHost demo.
Add const attribute to the Mass Storage Host driver functions where it was applicable, but missing.
15 years ago
5e14c194c9
Fixed Set/Clear Feature requests directed to a non-configured endpoint not returning a stall to the host.
...
Make TeensyHID bootloader use an 8 byte control endpoint to match the official Teensy, just in case Paul decides to authenticate on that attribute in the future.
15 years ago
7b79325aa0
Removed two-step endpoint/pipe bank clear and switch sequence for smaller, faster endpoint/pipe code.
...
Added spacing between multiple paragraphs in Doxygen \note sections.
Removed call to the clock prescaler reset function in the Teensy bootloader to save space - the user application is accessed via a watchdog reset anyway, so the prescale reset would only affect the speed of the bootloader itself.
15 years ago
19ecd04f37
Removed invalid dfu and flip related targets from the bootloaders - bootloaders can only be replaced with an external programmer.
15 years ago
e55f338663
Document the Bluetooth ACL layer. Remove unneeded parameters from the signalling command processing routines.
...
Change over the code so that the bluetooth packet data is read in by the stack rather than the user application, to make it more unform for sending/receiving, and so the library can handle incomming fragmentation in the future.
Start Service Discovery Protocol decoding and processing.
15 years ago
797130bddc
Bluetooth demo can now create and maintain logical channels - need to determine why Windows machines refuse to connect.
15 years ago
ee74b4948f
Add information request/response signal handler to the Bluetooth Host demo.
...
Ensure that the AVRISP-MKII project's Windows avrdude compatibility define is named properly in all parts of the code.
15 years ago
fa1a092901
Add user callback function to the Bluetooth host demo to filter out connections from remote devices. Add in ability to reject connections based on their bluetooth device address.
...
Clean up RelayBoard project code.
Make AVRISP project clear the XMEGA target's reset register twice; this does not appear to take affect properly the first time under some circumstances.
15 years ago
a2e6d54336
Massive cleanups to the incomplete BluetoothHost demo, to make the HCL layer code much easier to read, block less and work correctly.
15 years ago
c9148f9b47
Added WIN_LIBUSB_COMPAT compile time option to the AVRISP programmer project to make the code compatible with Windows builds of avrdude at the expense of AVRStudio compatibility.
15 years ago
de8313cd9b
Add updated board driver directory summaries to the documentation.
15 years ago
d4c421e380
Oops - make sure board driver dispatch headers test for the correct BOARD define values.
...
Add button support for the BENITO board target.
15 years ago
61a799ed55
Added support for the JM-DB-U2 board hardware.
15 years ago
Dean Camera