c43605612d
Lower bulk endpoint polling rate in the descriptors to the lowest possible value to give maximum throughput.
14 years ago
3988639823
Oops - reduce size of each ring buffer in the USBtoSerial and Benito projects so that the RAM is not overflowed on the smaller USB AVR targets (thanks to Andrei from Microsin.ru).
14 years ago
8f7437dda2
Rename incorrectly named XPROGTarget_SendBreak() function to XPROGTarget_SendIdle(), as it is sending idle bits and not break bits.
14 years ago
cbc00c843a
Fixed AVRISP-MKII clone project not starting the target's program automatically after exiting TPI programming mode.
14 years ago
a9f313afa9
Slow AVRISP-MKII clone PDI/TPI programming speed back to 250KHz due to issues with the XPLAINBridge when PDI programming at faster rates.
...
Speed up XMEGANVM_WaitWhileNVMControllerBusy() by preloading the status register address into the pointer register of the target's NVM controller and then reading via a faster indirect load command.
14 years ago
002cd6df49
Added new XCK_RESCUE_CLOCK_ENABLE compile time option to the AVRISP-MKII clone programmer project (thanks to Tom Light).
14 years ago
b27f35536d
Fixed incorrect event name in the Benito project.
14 years ago
f2324fc2b4
Second patch to fix incorrect PDI/TPI programming speed.
14 years ago
d41cd9a41a
Fixed PDI/TPI programming speed of ~250KHz in the AVRISP-MKII Clone project, instead of the desired 500KHz.
14 years ago
50390867e7
Fixed incorrect PollingIntervalMS values in the demo/project/bootloader endpoint descriptors (thanks to MCS Electronics).
14 years ago
0ce2950d81
Added board hardware driver support for the Adafruit U4 breakout board.
...
Fixed calculation of timer register reload values derived from F_CPU; must subtract one from the division result for the compare value to be correct.
Change AVRISP-MKII rescue clock speed to 4MHz to ensure that a 125KHz ISP speed works regardless of the target's fuses (i.e. DIV8 set).
14 years ago
bac860b173
Fixed broken input in the MagStripe reader project due to an incorrect HID report descriptor.
14 years ago
fb76acb084
Renamed the EVENT_USB_Device_UnhandledControlRequest() event to EVENT_USB_Device_ControlRequest() as it is now fired before the library request handlers, not afterwards.
14 years ago
85cf202737
Fixed USBtoSerial and XPLAINBridge demos discarding data from the PC if the send buffer becomes full.
14 years ago
5ce8380a7d
Fix XPLAINBridge code broken during the changes to the Rescue Clock generation in the AVRISP-MKII clone project.
...
Change over all low level host mode project's descriptor comparator routines to perform the descriptor casting in a temp variable to make the code clearer and easier to modify (despite being more verbose).
14 years ago
3bf760ad7d
Rescue clock of the AVRISP-MKII moved to the AVR's OCR1A pin, so that the clock can be generated at all times when 125KHz ISP programming mode is selected.
14 years ago
cb779e3d7d
Changed over www.fourwalledcubicle.com links to the new www.lufa-lib.org redirect domain, including the new aliased links for LUFA-related pages such as the various download/source control mirrors and support lists.
14 years ago
55538dcef3
Add descriptor class, subclass and protocol constants to the class drivers, modify all demos to use them where possible.
...
Move out private/internal host class driver constants to the common class driver headers, so that they can be used in the Low Level host mode demos.
Ensure all demos, projects and bootloaders use the class driver constants where possible to minimise code repetition.
14 years ago
b37d77eab3
All USB class drivers are now automatically included when LUFA/Drivers/USB.h is included, and no longer need to be seperately included.
...
All LowLevel demos changed to use the constants and types defined in the USB class drivers.
14 years ago
421479a4b9
Fix incomplete StandaloneProgrammer project code not compiling due to the recent API changes in the LUFA core.
14 years ago
31daf04c6a
Fix SoftUART.c not compiling due to accidental check in of changes not yet complete in the rest of the XPLAINBridge project code.
14 years ago
3661ae8dfb
Minor documentation corrections.
14 years ago
5a4def7478
Clean up excessive whitespace at the end of each line using the wspurify tool made by Laszlo Monda
14 years ago
3693916cd3
Fix Webserver project code not compiling due to the changes to the USB mode selection constant names.
14 years ago
3a03da9705
Fixed ISR definition conflict in the XPLAIN bridge between the software UART and the AVRISP-MKII ISP modules.
14 years ago
93793679c9
Revert change to the AVRISP-MKII project for fuse byte programming via the CMDEX bit - this appears to be an error in the XMEGA manual external memory programming table.
14 years ago
a447ae134f
Fixed broken lock byte programming in the AVRISP-MKII clone project for some XMEGA targets.
14 years ago
824ce10390
Fixed broken FLASH/EEPROM programming in the AVRISP-MKII clone project when writing in non-paged mode and the polling byte cannot be used.
14 years ago
c8942ef469
Fixed LowLevel JoystickHostWithParser demo not saving the chosen HID interface's report descriptor size.
...
Simplified low level Host demo configuration descriptor parser routines.
14 years ago
7166c7ba3e
Fix low level host mode demos not correctly fetching the next endpoint when an invalid interface is discarded.
...
Update the pipe configuration routines in the host mode class drivers so that they use the same new code to enumerate compatible devices to increase reliability. Add support to the host mode class drivers for non-sequential (but non-overlapping with other interface) pipe numbers.
14 years ago
158afe9109
Reverted Endpoint/Pipe non-sequential configuration hack, placed restriction on the configuration order instead to ensure maximum reliability.
...
Altered all low level device and host mode demos to ensure that endpoints and pipes are configured in ascending order properly.
Rewrote all low level host mode demos' configuration descriptor parser code to ensure that pipes are enumerated in ascending order, and to ensure maximum compatibility with devices.
Incremented all device mode demo's device descriptor revision numbers to ensure that any descriptor changes are re-fetched on machines which have enumerated previous versions.
14 years ago
a509729b2d
Changed default value for the reset polarity parameter in the AVRISP-MKII project so that it defaults to active low drive.
...
Fixed incorrect USB_DeviceState value when unconfiguring the device without an address set.
14 years ago
713670043a
Move out many of the common class driver constants into grouped enums, to make them more managable.
...
Add new CDC descriptor structs to the CDC class driver, so that the CDC demos can use human readable field names.
Rename prefix for Still Image Host class driver functions from "SImage_" to "SI_" to remain consistent with the rest of the driver.
14 years ago
800485bd95
Remove dfu-programmer program switches, to ensure maximum compatibility with all dfu-programmer versions.
14 years ago
bd85422d2b
Added the --suppress-bootloader-mem option to the makefile dfu target, to ensure that writes to the bootloader section of the AVR's flash memory are ignored (thanks to Axel Rohde).
...
Fixed incorrect command name for EEPROM memory programming in the makefile dfu-ee target.
Makefile whitespace fixes.
14 years ago
6d2f091cec
Make project makefiles correctly clean intermeditary build files from assembly and C++ sources (thanks to Daniel Czigany).
14 years ago
84696c727d
Added board hardware driver support for the BUI development board.
14 years ago
def0e0ff1b
Remove incomplete MIDIToneGenerator project.
14 years ago
fdcb486e22
Fix typos in the project overview text files.
14 years ago
c166dfc64e
Added class specific descriptor type defines with standard USB-IF element naming.
14 years ago
4dece08bef
Clarify in the project documentation files what the each of the different USB AVR device "series" comprises of.
14 years ago
009eebf229
Fix incorrect ADC driver documentation for the parameters of ADC_Init(), fix incorrect call to ADC_Init() in the TemperatureDatalogger project.
14 years ago
b3c6599bb7
Remove remaining void* descriptor casts in the projects and demos that were not removed when the GetDescriptor callback function's signature was altered.
14 years ago
263178fbb6
Add better description of the Ultra-Lightweight Ring Buffer header files.
14 years ago
092f82e06f
Changed the signature of the CALLBACK_USB_GetDescriptor() callback function so that the descriptor pointer is const, to remove the need for extra casting inside the callback (thanks to Jonathan Kollasch).
14 years ago
1be3436e89
Moved calls to Device mode Class Driver events to after the request has been acknowledged, so that long event handlers do do skew the timing of the control requests.
...
Fixed USBtoSerial and Benito project SetLineEncoding calls failing if the USART is busy, due to the RX ISR delaying the control request handler.
14 years ago
81998ce297
Added compile time error to the AVRISP-MKII project when built for the U4 chips, as the default VTARGET detection ADC channel does not exist on these chips (thanks to Marco).
14 years ago
4f114e5766
Fixed MassStorage based demos and projects resetting the SCSI sense values before the command is executed, leading to missed SCSI sense values when the host retrieves the sense key (thanks to Martin Degelsegger).
...
Added missing DataflashManager_CheckDataflashOperation() function to the MassStorageKeyboard demo, removed redundant SCSI_Codes.h file as these values are part of the MassStorage Class Driver.
14 years ago
508e905d8d
Removed complicated logic for the Endpoint_ConfigureEndpoint() function to use inlined or function called versions depending of if the given bank size is a compile time constant, as the compiler does a better job of optimizing with basic code.
...
Changed over all device demos to use a clearer algorithm for the configuring of the application's endpoints.
14 years ago
9274610a48
Commit for the 100807 release.
14 years ago
Dean Camera