Make M303 silent when "S0" is sent

If S is left out perhaps it should be silent, but check the spec for
this M code.
master
Scott Lahteine 12 years ago
parent a200521eab
commit 0ef54f2f85

@ -298,7 +298,7 @@ const bool Z_ENDSTOPS_INVERTING = true; // set to true to invert the logic of th
// #define EXTRUDER_OFFSET_X {0.0, 20.00} // (in mm) for each extruder, offset of the hotend on the X axis
// #define EXTRUDER_OFFSET_Y {0.0, 5.00} // (in mm) for each extruder, offset of the hotend on the Y axis
// The speed change that does not require acceleration (i.e. the software might assume it can be done instanteneously)
// The speed change that does not require acceleration (i.e. the software might assume it can be done instantaneously)
#define DEFAULT_XYJERK 20.0 // (mm/sec)
#define DEFAULT_ZJERK 0.4 // (mm/sec)
#define DEFAULT_EJERK 5.0 // (mm/sec)

@ -1449,13 +1449,18 @@ void process_commands()
#if defined(LARGE_FLASH) && LARGE_FLASH == true && defined(BEEPER) && BEEPER > -1
case 300: // M300
{
int beepS = 1;
int beepP = 1000;
if(code_seen('S')) beepS = code_value();
if(code_seen('P')) beepP = code_value();
tone(BEEPER, beepS);
delay(beepP);
noTone(BEEPER);
int beepS = code_seen('S') ? code_value() : 110;
int beepP = code_seen('P') ? code_value() : 1000;
if (beepS > 0)
{
tone(BEEPER, beepS);
delay(beepP);
noTone(BEEPER);
}
else
{
delay(beepP);
}
}
break;
#endif // M300

Loading…
Cancel
Save