Fix for Z-endstop failure in .22

master
Marcio Teixeira 7 years ago
parent c4af48013e
commit 1fc0a8f206

@ -37,7 +37,7 @@
#error Must specify model and toolhead. Please see "Configuration_LulzBot.h" for directions.
#endif
#define LULZBOT_FW_VERSION ".22"
#define LULZBOT_FW_VERSION ".23"
// Select options based on printer model
@ -141,6 +141,12 @@
#define LULZBOT_Z_MIN_PROBE_ENDSTOP
#define LULZBOT_Z_MIN_PROBE_PIN SERVO0_PIN // Digital pin 22
#define LULZBOT_BAUDRATE 250000
// On the TAZ, the bed washers are on Z_MIN_PROBE while the
// Z-Home button is on Z_MIN, yet we need both to be disabled
// when z_probe_enabled is false. We added this special case
// to "endstops.cpp"
#define LULZBOT_Z_MIN_USES_Z_PROBE_ENABLED
#endif
#define LULZBOT_USE_CONTROLLER_FAN
@ -298,7 +304,7 @@
*
* On TAZ:
* Z_MIN_PIN corresponds to the Z-Home push button.
* LULZBOT_Z_MIN_PROBE_PIN are the bed washers.
* Z_MIN_PROBE_PIN are the bed washers.
*/
#if defined(LULZBOT_MINI_BED)
#define LULZBOT_ENABLE_PROBE_PINS(enable) { \
@ -321,12 +327,16 @@
WRITE(LULZBOT_Z_MIN_PROBE_PIN, HIGH); \
SET_INPUT(Z_MIN_PIN); \
WRITE(Z_MIN_PIN, HIGH); \
/* The following is required since Marlin would \
* not normally deploy the probe for Z-Min */ \
endstops.enable_z_probe(true); \
} else { \
/* Ground both pins to prevent EMI */ \
SET_OUTPUT(LULZBOT_Z_MIN_PROBE_PIN); \
WRITE(LULZBOT_Z_MIN_PROBE_PIN, LOW); \
SET_OUTPUT(Z_MIN_PIN); \
WRITE(Z_MIN_PIN, LOW); \
endstops.enable_z_probe(false); \
} \
}
#endif

@ -3917,6 +3917,8 @@ inline void gcode_G28(const bool always_home_all) {
#endif // !DELTA (gcode_G28)
LULZBOT_AFTER_Z_HOME_ACTION // This must happen before endstops.not_homing()
endstops.not_homing();
#if ENABLED(DELTA) && ENABLED(DELTA_HOME_TO_SAFE_ZONE)
@ -3935,8 +3937,6 @@ inline void gcode_G28(const bool always_home_all) {
tool_change(old_tool_index, 0, true);
#endif
LULZBOT_AFTER_Z_HOME_ACTION
lcd_refresh();
report_current_position();

@ -409,7 +409,7 @@ void Endstops::update() {
#else // !Z_DUAL_ENDSTOPS
#if ENABLED(Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN)
#if ENABLED(Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN) || defined(LULZBOT_Z_MIN_USES_Z_PROBE_ENABLED)
if (z_probe_enabled) UPDATE_ENDSTOP(Z, MIN);
#else
UPDATE_ENDSTOP(Z, MIN);

Loading…
Cancel
Save