Fix mistakes in the XPROGTarget.c/.h files for TPI mode software USART clock rate and PDI mode XPLAIN board autoconfiguration.

pull/1469/head
Dean Camera 15 years ago
parent 8301dc553e
commit d15cbdd490

@ -145,6 +145,8 @@ ISR(TIMER1_COMPB_vect, ISR_BLOCK)
/** Enables the target's PDI interface, holding the target in reset until PDI mode is exited. */
void XPROGTarget_EnableTargetPDI(void)
{
IsSending = false;
#if defined(XPROG_VIA_HARDWARE_USART)
/* Set Tx and XCK as outputs, Rx as input */
DDRD |= (1 << 5) | (1 << 3);
@ -160,10 +162,6 @@ void XPROGTarget_EnableTargetPDI(void)
UBRR1 = (F_CPU / 1000000UL);
UCSR1B = (1 << TXEN1);
UCSR1C = (1 << UMSEL10) | (1 << UPM11) | (1 << USBS1) | (1 << UCSZ11) | (1 << UCSZ10) | (1 << UCPOL1);
/* Send two BREAKs of 12 bits each to enable PDI interface (need at least 16 idle bits) */
XPROGTarget_SendBreak();
XPROGTarget_SendBreak();
#else
/* Set DATA and CLOCK lines to outputs */
BITBANG_PDIDATA_DDR |= BITBANG_PDIDATA_MASK;
@ -174,20 +172,22 @@ void XPROGTarget_EnableTargetPDI(void)
asm volatile ("NOP"::);
asm volatile ("NOP"::);
/* Fire timer compare channel A ISR every 90 cycles to manage the software USART */
OCR1A = 90;
/* Fire timer compare channel A ISR to manage the software USART */
OCR1A = BITS_BETWEEN_USART_CLOCKS;
TCCR1B = (1 << WGM12) | (1 << CS10);
TIMSK1 = (1 << OCIE1A);
#endif
/* Send two BREAKs of 12 bits each to enable TPI interface (need at least 16 idle bits) */
/* Send two BREAKs of 12 bits each to enable PDI interface (need at least 16 idle bits) */
XPROGTarget_SendBreak();
XPROGTarget_SendBreak();
#endif
}
/** Enables the target's TPI interface, holding the target in reset until TPI mode is exited. */
void XPROGTarget_EnableTargetTPI(void)
{
IsSending = false;
/* Set /RESET line low for at least 90ns to enable TPI functionality */
RESET_LINE_DDR |= RESET_LINE_MASK;
RESET_LINE_PORT &= ~RESET_LINE_MASK;
@ -204,10 +204,6 @@ void XPROGTarget_EnableTargetTPI(void)
UBRR1 = (F_CPU / 1000000UL);
UCSR1B = (1 << TXEN1);
UCSR1C = (1 << UMSEL10) | (1 << UPM11) | (1 << USBS1) | (1 << UCSZ11) | (1 << UCSZ10) | (1 << UCPOL1);
/* Send two BREAKs of 12 bits each to enable TPI interface (need at least 16 idle bits) */
XPROGTarget_SendBreak();
XPROGTarget_SendBreak();
#else
/* Set DATA and CLOCK lines to outputs */
BITBANG_TPIDATA_DDR |= BITBANG_TPIDATA_MASK;
@ -216,15 +212,15 @@ void XPROGTarget_EnableTargetTPI(void)
/* Set DATA line high for idle state */
BITBANG_TPIDATA_PORT |= BITBANG_TPIDATA_MASK;
/* Fire timer capture channel B ISR every 90 cycles to manage the software USART */
OCR1B = 9;
/* Fire timer capture channel B ISR to manage the software USART */
OCR1B = BITS_BETWEEN_USART_CLOCKS;
TCCR1B = (1 << WGM12) | (1 << CS10);
TIMSK1 = (1 << OCIE1B);
#endif
/* Send two BREAKs of 12 bits each to enable TPI interface (need at least 16 idle bits) */
XPROGTarget_SendBreak();
XPROGTarget_SendBreak();
#endif
}
/** Disables the target's PDI interface, exits programming mode and starts the target's application. */

@ -56,29 +56,7 @@
/* Defines: */
#if ((BOARD == BOARD_XPLAIN) || (BOARD == BOARD_XPLAIN_REV1))
// #define XPROG_VIA_HARDWARE_USART
#define BITBANG_PDIDATA_PORT PORTD
#define BITBANG_PDIDATA_DDR DDRD
#define BITBANG_PDIDATA_PIN PIND
#define BITBANG_PDIDATA_MASK (1 << 3)
#define BITBANG_PDICLOCK_PORT PORTD
#define BITBANG_PDICLOCK_DDR DDRD
#define BITBANG_PDICLOCK_PIN PIND
#define BITBANG_PDICLOCK_MASK (1 << 5)
#define BITBANG_TPIDATA_PORT PORTB
#define BITBANG_TPIDATA_DDR DDRB
#define BITBANG_TPIDATA_PIN PINB
#define BITBANG_TPIDATA_MASK (1 << 3)
#define BITBANG_TPICLOCK_PORT PORTB
#define BITBANG_TPICLOCK_DDR DDRB
#define BITBANG_TPICLOCK_PIN PINB
#define BITBANG_TPICLOCK_MASK (1 << 1)
#define XPROG_VIA_HARDWARE_USART
#else
#define BITBANG_PDIDATA_PORT PORTB
#define BITBANG_PDIDATA_DDR DDRB
@ -101,55 +79,58 @@
#define BITBANG_TPICLOCK_MASK (1 << 1)
#endif
/** Number of cycles between each clock when software USART mode is used */
#define BITS_BETWEEN_USART_CLOCKS 100
/** Total number of bits in a single USART frame */
#define BITS_IN_USART_FRAME 12
#define PDI_CMD_LDS 0x00
#define PDI_CMD_LD 0x20
#define PDI_CMD_STS 0x40
#define PDI_CMD_ST 0x60
#define PDI_CMD_LDCS 0x80
#define PDI_CMD_REPEAT 0xA0
#define PDI_CMD_STCS 0xC0
#define PDI_CMD_KEY 0xE0
#define PDI_STATUS_REG 0
#define PDI_RESET_REG 1
#define PDI_CTRL_REG 2
#define PDI_STATUS_NVM (1 << 1)
#define PDI_RESET_KEY 0x59
#define PDI_NVMENABLE_KEY (uint8_t[]){0x12, 0x89, 0xAB, 0x45, 0xCD, 0xD8, 0x88, 0xFF}
#define PDI_DATSIZE_1BYTE 0
#define PDI_DATSIZE_2BYTES 1
#define PDI_DATSIZE_3BYTES 2
#define PDI_DATSIZE_4BYTES 3
#define PDI_POINTER_INDIRECT 0
#define PDI_POINTER_INDIRECT_PI 1
#define PDI_POINTER_DIRECT 2
#define TPI_CMD_SLD 0x20
#define TPI_CMD_SST 0x60
#define TPI_CMD_SSTPR 0x68
#define TPI_CMD_SIN 0x10
#define TPI_CMD_SOUT 0x90
#define TPI_CMD_SLDCS 0x80
#define TPI_CMD_SSTCS 0xC0
#define TPI_CMD_SKEY 0xE0
#define TPI_STATUS_REG 0x00
#define TPI_CTRL_REG 0x02
#define TPI_ID_REG 0x0F
#define TPI_STATUS_NVM (1 << 1)
#define TPI_NVMENABLE_KEY (uint8_t[]){0x12, 0x89, 0xAB, 0x45, 0xCD, 0xD8, 0x88, 0xFF}
#define TPI_POINTER_INDIRECT 0
#define TPI_POINTER_INDIRECT_PI (1 << 2)
#define BITS_IN_USART_FRAME 12
#define PDI_CMD_LDS 0x00
#define PDI_CMD_LD 0x20
#define PDI_CMD_STS 0x40
#define PDI_CMD_ST 0x60
#define PDI_CMD_LDCS 0x80
#define PDI_CMD_REPEAT 0xA0
#define PDI_CMD_STCS 0xC0
#define PDI_CMD_KEY 0xE0
#define PDI_STATUS_REG 0
#define PDI_RESET_REG 1
#define PDI_CTRL_REG 2
#define PDI_STATUS_NVM (1 << 1)
#define PDI_RESET_KEY 0x59
#define PDI_NVMENABLE_KEY (uint8_t[]){0x12, 0x89, 0xAB, 0x45, 0xCD, 0xD8, 0x88, 0xFF}
#define PDI_DATSIZE_1BYTE 0
#define PDI_DATSIZE_2BYTES 1
#define PDI_DATSIZE_3BYTES 2
#define PDI_DATSIZE_4BYTES 3
#define PDI_POINTER_INDIRECT 0
#define PDI_POINTER_INDIRECT_PI 1
#define PDI_POINTER_DIRECT 2
#define TPI_CMD_SLD 0x20
#define TPI_CMD_SST 0x60
#define TPI_CMD_SSTPR 0x68
#define TPI_CMD_SIN 0x10
#define TPI_CMD_SOUT 0x90
#define TPI_CMD_SLDCS 0x80
#define TPI_CMD_SSTCS 0xC0
#define TPI_CMD_SKEY 0xE0
#define TPI_STATUS_REG 0x00
#define TPI_CTRL_REG 0x02
#define TPI_ID_REG 0x0F
#define TPI_STATUS_NVM (1 << 1)
#define TPI_NVMENABLE_KEY (uint8_t[]){0x12, 0x89, 0xAB, 0x45, 0xCD, 0xD8, 0x88, 0xFF}
#define TPI_POINTER_INDIRECT 0
#define TPI_POINTER_INDIRECT_PI (1 << 2)
/* Function Prototypes: */
void XPROGTarget_EnableTargetPDI(void);

Loading…
Cancel
Save