9a5ae36a4f
Software PDI mode breaks unless the software USART has 100 cycles between bits.
15 years ago
2b74b517ea
Don't enable the pullup on the target /RESET line in the AVRISP project for PDI mode - clearing the XMEGA's reset control register twice is enough to release it from reset. Possible silicon bug, since the official Atmel programmers have the same issue.
15 years ago
39d56aeffe
Fixed PDI programming mode in the AVRISP programmer project not exiting programming mode correctly (clear target Reset key twice, set /RESET pin to pullup).
...
Add newlines to the MIDI event printf() statements in the MIDI host demos.
15 years ago
071fd8ce53
Revert changes made for the partial port to the AVR32 architecture.
15 years ago
e11fddfe66
Update Temperature board driver to be AVR32 compatible when the ADC peripheral driver is eventually ported. Make architecture includes explicit for both the AVR32 and the AVR8, to make way for future architecture ports.
...
Add SPI driver aliases for the old function names in the AVR8 driver, so that existing code will still compile against the new version.
15 years ago
c24027f3b5
Fixed software PDI/TPI programming mode in the AVRISP project not correctly toggling just the clock pin.
...
Fix broken AVR8 Serial peripheral driver.
15 years ago
d2851b3351
Oops - need to revert changes made to ease testing of the software PDI programming mode.
15 years ago
5e12d436fa
Remove dual ISR for software PDI mode, use a single ISR instead to reduce code complexity.
15 years ago
e322f14620
More fixes to the AVRISP command timeout system so that it should no longer lock up while processing command no matter what the conditions.
15 years ago
12a01ed72d
Increased the speed of both software and hardware TPI/PDI programming modes of the AVRISP project.
15 years ago
10b9394a8b
Oops - missed a few references to the old global TimeoutMSRemaining counter in ISPTarget.c of the AVRISP-MKII clone project.
15 years ago
ce8d0424b1
AVRISP programmer project now has a more robust timeout system, allowing for a doubling of the software USART speed for PDI and TPI programming.
15 years ago
de0ccb3d09
Add NO_VTARGET_DETECT compile time option to the AVRISP-MKII clone project, to disable VTARGET detection on AVR models with an on-chip ADC.
15 years ago
3a2c1db675
Fixed lack of SECTION ERASE command in TPI programming mode of the AVRISP project preventing fuses from being cleared.
15 years ago
ab195ab1da
Added .5MHz recovery clock to the AVRISP programmer project when in ISP programming mode to correct mis-set fuses.
...
Fixed AVRISP project not extending the command delay after each successful page/word/byte program.
15 years ago
35a0fe9384
Fixed USB_GetHIDReportSize() returning the number of bits in the specified report instead of bytes.
...
Moved the USB_GetHIDReportItemInfo() calls into the main report item passing loop in the *HostWithParser demos - it is fast enough not to effect performance, and avoids duplicate code.
Make Webserver project report the LUFA version as part of the HTTP header.
15 years ago
3ab0b3a027
Fix LowLevel Keyboard demo -- accidentally trying to dereference a uint8_t type in ProcessLEDReport().
15 years ago
7ae91099e9
Fix AVRISP-MKII clone project's TPI Chip Erase command processing - ensure erase location is the high byte in the given address space, check NVMBUSY for completion rather than the NVM Bus Enable bit.
...
Change If-Else chains over to switch statements in XPROGProtocol.c for clarity.
15 years ago
15f84bb8f5
New BOARD value option BOARD_NONE (equivelent to not specifying BOARD) which will remove all board hardware drivers which do not adversely affect the code operation (currently only the LEDs driver).
...
Spell-check code/comments in the Webserver/AVRISP-MKII projects.
15 years ago
77e86e7d82
Exlude the "INCLUDE_FROM_*" macros from the individual project's documentation.
15 years ago
53eca61d02
Minor fixups to the documentation and preprocessor tokens.
15 years ago
5687ac7316
Fix TPI mode chip erase code not properly erasing the target memory space.
15 years ago
8d49480891
Oops - new Write Word alignment code in the TPI programming function means that the WriteBuffer parameter is no longer const.
15 years ago
ec6fbb219f
Make TPI writes add a dummy high byte if the data isn't word-aligned.
15 years ago
b736a5ef2b
Make TPI programming protocol program in words, not bytes to satisfy the datasheet conditions.
15 years ago
4d246a82cb
Fixed incorrect values of USB_CONFIG_ATTR_SELFPOWERED and USB_CONFIG_ATTR_REMOTEWAKEUP tokens (thanks to Claus Christensen).
...
Mark the AVRISP-MKII project descriptors as being both Bus Powered and Device Powered.
Copy over file level documentation of the peripheral drivers to the module level documentation.
15 years ago
9e7ffcb014
Make AVRISP XPROG function parameters const where possible.
15 years ago
5f363996e3
Fixed issues with EEPROM and FLASH ISP programming in the AVRISP project.
15 years ago
331e8dece6
Use _delay_us() function in the XPROGTarget.c file to ensure timing requirements are met, rather than a fixed number of NOPs.
15 years ago
75d27f8ef0
Oops - PDI handshake delay was too long, causing the device's /RESET functionality to be re-enabled.
15 years ago
a114878209
Oops - TPI programming is broken in the AVRISP project because the busy-flag check wasn't inverting the result.
15 years ago
872f61ff53
Fix TPI communications in the AVRISP project when bit-banged USART mode is selected.
15 years ago
cec699ac59
Clean up Webserver project - add more Doxygen documentation for the new DHCP client functions and defines.
15 years ago
1aeb5056d6
Ensure TPI enable timing requirements are met in AVRISP-MKII programmer. Remove invalid code in the TPI read/write functions.
15 years ago
2059fd8b1a
Manually pull PDI clock pin high for 1ms before disabling PDI mode in the AVRISP-MKII project, to ensure that the PDI bus is disabled in the target and /RESET functionality restored.
15 years ago
db420853ce
Add Webserver project Doxygen configuration file and overview document.
...
Fix Doxygen configuration files' input file exclusion filters.
15 years ago
74b6993d66
Cleanup and partially fix AVRISP-MKII project's TPI programming support.
15 years ago
857381185d
ADC2 and ADC3 channels do not exist on the U4 series USB AVRs.
15 years ago
5d5e359076
Minor code cleanups, remove TemperatureDataLogger host application's Visual Studio Solution files, add LibHIDNet license files.
15 years ago
b68f7f1649
Added explicit ADC channel masks for the standard set of ADC channels, as the single-ended channel MUX masks are not equal to the channel number on some AVR models. Changed demos to use the new channel masks when using the ADC driver.
15 years ago
dd995683ea
Enhance TemperatureDatalogger project -- add RTC capabilities so that data is logged along with the current time and date. Make logging interval configurable, set by a C# PC host application.
15 years ago
1d2bc47eba
Clean up of the altered XPLAINBridge project.
15 years ago
60fd0ff418
Changed XPLAINBridge project to be both a USB to USART bridge and a PDI programmer, based on the state of a mode select pin.
15 years ago
f3d370a777
Clean up and add more comments to the AVRISP-MKII project. Make sure the SPI_MULTI command handler supports multiple packet responses. Use slightly smaller/faster repeated indirect-load commands when retrieving the PDI target's memory CRCs.
15 years ago
efb6c35778
Update Doxygen configuration files to the latest Doxygen version.
15 years ago
d97db1120b
Added support to the MIDI Class drivers for packed data, where multiple MIDI events are packed into a single USB packet. Added new MIDI Class driver flush routines to override packing behaviour.
15 years ago
7f9f97c792
Update copyright year to 2010.
15 years ago
f5951d1593
Reduced guard bit time in the AVRISP project PDI/TPI protocols to reduce the time needed to reverse the data communication direction.
15 years ago
b1dbd92c32
Fixed AVRISP PDI race condition where the guard time between direction changes could be interpreted as a start bit. Fixed TPI interface lines not being changed correctly when in bit-banged TPI mode.
15 years ago
e1c1c25619
Change the AVRISP project's RESET LINE makefile tokens to AUX LINE, as it is not always used for target reset.
15 years ago
93fe420d89
Minor documentation updates.
15 years ago
4600fd0cb6
Fix TPI NVM Write handler -- AVRStudio sends out writes in page sized chunks, not byte sized chunks.
15 years ago
7c8f4a716f
Add first draft of the TPI NVM commands for reading, writing and erasing a target. Needs testing when physical access to a part is available.
15 years ago
3222f21b84
Add dummy undocumented TPI XPROG parameters to the AVRISP project so that TPI programming mode can be entered.
15 years ago
d4ca7fb44c
Fix MIT license language to make its intent clearer.
15 years ago
d15cbdd490
Fix mistakes in the XPROGTarget.c/.h files for TPI mode software USART clock rate and PDI mode XPLAIN board autoconfiguration.
15 years ago
8301dc553e
Fix references to the renamed AVRISP-MKII project folder.
15 years ago
8ecdc2b144
Rename AVRISP project folder to AVRISP-MKII.
15 years ago
Dean Camera