eed7d4df6a
Added new ENDPOINT_*_BusSuspended error code to the Endpoint function, so that the stream functions early-abort if the bus is suspended before or during a transfer.
15 years ago
5c0c0327d5
Increase hardware PDI/TPI programming speed to 1MHz in the AVRISP MKII clone project.
15 years ago
a5e79333e5
Switch back to C based timeout ISR in the AVRISP project - assembly version was failing, and only one or two cycles could be shaved off the compiler generated code.
15 years ago
3d28d53c3e
Change AVRISP project's timeout to be interrupt based again, but make the interrupt itself interruptable and use a seperate assembly file to hand-optimize the ISR code.
...
Removed the cast to uint16_t on the set baud rate in the USBtoSerial project, so that the higher >1M baud rates can be selected (thanks to Steffan).
15 years ago
9a1560dc05
Make sure that long reads are aborted early if the connection times out while waiting on more bytes in the AVRISP MKII clone project.
15 years ago
ceb16ee24f
Make sure that the NVM bus/controller busy waits in the AVRISP MKII clone project abort properly if a timeout occurs while waiting for a response.
15 years ago
9cad677ebb
The Audio_Device_IsSampleReceived() and Audio_Device_IsReadyForNextSample() functions are now inline, to reduce overhead.
15 years ago
9e34144c9b
Use puts_P() and printf_P() instead of the normal variants where possible in the Host mode Class Driver demos.
15 years ago
0063f72117
Oops - relocated USBInterrupt.h header file requires adjusted include paths for the other USB driver header files.
15 years ago
e977774d4e
Relocate USBInterrupt.c/.h from the HighLevel USB driver directory to the LowLevel directory as it is hardware-dependent.
15 years ago
1090e767f1
Remove incomplete/nonfunctional MIDI class bootloader.
15 years ago
59c4871f80
USB_Init() no longer calls sei() to enable global interrupts - this must now be done in the user application once all init code has run.
15 years ago
85aaaf84ce
Make AVRISP-MKII clone project's software PDI/TPI mode more robust by keeping track of timeouts while waiting for a Tx/Rx to finish.
15 years ago
3c7ff36cfd
Fix TeensyHID bootloader Doxygen configuration file's CREATE_SUBDIRS options set to true instead of false (thanks to Andrei Krainev).
15 years ago
5993e1efe7
Added ability to search by Channel PSM to the GetChannelData() function in the BluetoothHost demo.
...
Added new HCI states to properly initialize the bluetooth dongle and retrieve the local BDADDR.
Factored out Bluetooth state information into a new state structure for easy reference in the user application.
Added new StackInitialized() Bluetooth stack callback function.
15 years ago
8252b4febd
Fixed HID Device Class Driver not allocating a temporary buffer when the host requests a report via the control endpoint and the user has set the PrevReportINBuffer driver configuration element to NULL (thanks to Lars Noschinski).
...
Clean up incomplete BluetoothHost debugging commands to use GCC extension to avoid NULL parameters when no formatting is required.
15 years ago
d03d6513d0
Add start of a SDP service table, which will be linked to the Bluetooth SDP code.
15 years ago
d92e9133d3
Make bluetooth SDP code correctly unpack the search UUIDs and parameters.
...
Minor documentation improvements.
15 years ago
fc8e4837a9
Add const keyword to the demo function parameters where possible.
15 years ago
55db57e1ed
Add bluetooth channel connection callback to the incomplete BluetoothHost demo.
15 years ago
1f682ca2de
Minor documentation improvements.
15 years ago
3eb81df998
Rename FunctionAttributes.h to Attributes.h, as some attributes are applicable to variables also. Add new ATTR_NOINIT attribute for global variables.
...
Add the beginnings of a SDP implentation to the incomplete BluetoothHost demo.
Add const attribute to the Mass Storage Host driver functions where it was applicable, but missing.
15 years ago
5e14c194c9
Fixed Set/Clear Feature requests directed to a non-configured endpoint not returning a stall to the host.
...
Make TeensyHID bootloader use an 8 byte control endpoint to match the official Teensy, just in case Paul decides to authenticate on that attribute in the future.
15 years ago
7b79325aa0
Removed two-step endpoint/pipe bank clear and switch sequence for smaller, faster endpoint/pipe code.
...
Added spacing between multiple paragraphs in Doxygen \note sections.
Removed call to the clock prescaler reset function in the Teensy bootloader to save space - the user application is accessed via a watchdog reset anyway, so the prescale reset would only affect the speed of the bootloader itself.
15 years ago
19ecd04f37
Removed invalid dfu and flip related targets from the bootloaders - bootloaders can only be replaced with an external programmer.
15 years ago
e55f338663
Document the Bluetooth ACL layer. Remove unneeded parameters from the signalling command processing routines.
...
Change over the code so that the bluetooth packet data is read in by the stack rather than the user application, to make it more unform for sending/receiving, and so the library can handle incomming fragmentation in the future.
Start Service Discovery Protocol decoding and processing.
15 years ago
882ef0c983
Add some more documentation to the half-completed Bluetooth Host demo, fix the OpenChannel() command initialising the channel information structure to the wrong initial state once the CONNECTION REQUEST command has been sent to the remote device.
15 years ago
8b0ec6c5ca
Fix Bluetooth stack CONNECTION RESPONSE packets - for this command and this command only, the source/destination roles are switched. Reverse the Local/Remote channel ordering so that Windows mobile and other stacks which depend on valid channel values to connect.
15 years ago
6cfa3b7db8
Add HCI debugging with verbosity control to the BluetoothHost demo.
...
Add Link Key Request event processing so that paired devices always re-authenticate until appropriate link key store/retrieve callbacks are implemented.
15 years ago
26421b38cd
Fix up Bluetooth Demo's options processing on incoming channel configuration requests.
15 years ago
28f1ac8117
Add LUFA-side channel open/close routines, add signalling handlers for the creation and configuration of channels from the local device to the remote device, to add to the existing remote to local channel capabilities.
15 years ago
797130bddc
Bluetooth demo can now create and maintain logical channels - need to determine why Windows machines refuse to connect.
15 years ago
2a072db703
Make Bluetooth signalling handler routines use the generic Bluetooth_SendPacket() routine for their responses. Use a better method of controlling the debug output verbosity.
15 years ago
c77f136661
Add bidirectional channel configuration -- remote device is not ACKing sent Configuration Requests, needs further debugging. Implement Bluetooth spec's channel states.
...
Use abbreviations for the structure and function names where possible to try to cut down on the code verbosity.
15 years ago
b9c7d19615
Add packet reception and send routines to the ACL layer of the incomplete Bluetooth Host demo.
15 years ago
ee74b4948f
Add information request/response signal handler to the Bluetooth Host demo.
...
Ensure that the AVRISP-MKII project's Windows avrdude compatibility define is named properly in all parts of the code.
15 years ago
083d797aca
Add Bluetooth signalling echo request/response handlers, disconnection request/response handlers.
...
Add Bluetooth connection request/complete/disconnection callbacks.
Remove debugging from HCI layer, as it is now operational -- add guards to ACL debug statements to reduce logging chattyness so that the overall command sequences can be observed and debugged.
15 years ago
fa1a092901
Add user callback function to the Bluetooth host demo to filter out connections from remote devices. Add in ability to reject connections based on their bluetooth device address.
...
Clean up RelayBoard project code.
Make AVRISP project clear the XMEGA target's reset register twice; this does not appear to take affect properly the first time under some circumstances.
15 years ago
fd96b28882
More improvements to the incomplete BluetoothHost demo - add Disconnection Event processing.
...
Remove unused macro in the host mode demos for the maximum Configuration Descriptor size.
15 years ago
a2e6d54336
Massive cleanups to the incomplete BluetoothHost demo, to make the HCL layer code much easier to read, block less and work correctly.
15 years ago
c9148f9b47
Added WIN_LIBUSB_COMPAT compile time option to the AVRISP programmer project to make the code compatible with Windows builds of avrdude at the expense of AVRStudio compatibility.
15 years ago
ce46257ff2
Add RelayBoard project patch from OBinou.
15 years ago
de8313cd9b
Add updated board driver directory summaries to the documentation.
15 years ago
cf4c510ec3
Oops, incorrectly edited the Benito buttons driver file instead of the JM-DB-U2 buttons driver file.
...
Fix up preprocessor guards in the new board driver files.
15 years ago
ead183bc53
Add missing board Buttons driver for the USBTINY MKII board target.
15 years ago
d4c421e380
Oops - make sure board driver dispatch headers test for the correct BOARD define values.
...
Add button support for the BENITO board target.
15 years ago
61a799ed55
Added support for the JM-DB-U2 board hardware.
15 years ago
3790907f4d
Added board hardware driver support for the Benito programmer.
15 years ago
a8cbe3466b
Added board hardware driver support for Tom's USBTINY MKII programmer.
15 years ago
9257f4ab8e
Add briefs for the library core structures.
15 years ago
Dean Camera