Dean Camera
bb9fb1051c
Add better documentation to the Software UART code in the XPLAINBridge project.
15 years ago
Dean Camera
1c407b9669
Switch software UART over to timer 1 and remove timer prescaling to try to prevent integer rounding errors and thus minimize the possible error of the UART code.
15 years ago
Dean Camera
f64e3db07a
Rename software USART driver globals to make the code more in line with the rest of the XPLAINBridge project.
15 years ago
Dean Camera
79742c5d24
Make software USART used in the XPLAINBridge project directly check and store into the ring buffers, rather than polling from the main program loop to avoid added latency.
15 years ago
Dean Camera
9b29d1dc50
Create a new LightweightRingBuffer.h header file for the XPLAIN project to abstract out the new ring buffer without a performance penalty.
15 years ago
Dean Camera
9c037a952f
The RingBuff library code has been replaced in the XPLAINBridge project with an ultra lightweight buffer to help improve the reliability of the bridge.
15 years ago
Dean Camera
776485a6c5
Remove obsolete entry from the Doxygen configuration files.
15 years ago
Dean Camera
3e515cdfa8
Short UUIDs are measured in bytes, not bits -- update Service Discovery Protocol code so that it can now correctly match against UUIDs in the service table.
15 years ago
Dean Camera
a883cf65dc
Renamed CDC device class demos' ManagementEndpoint descriptor to NotificationEndpoint to more accurately indicate its purpose.
15 years ago
Dean Camera
f13bc35a19
Begin processing code for Service Discovery Protocol attributes.
15 years ago
Dean Camera
ff61dfa505
Fixed AVRISP project not sending a full erase-and-write EEPROM command to XMEGA targets when writing to the EEPROM instead of the split write-only command (thanks to Tim Margush).
15 years ago
Dean Camera
80d85090ba
Fixed AVRISP project sending a LOAD EXTENDED ADDRESS command to 128KB AVRs after programming or reading from the last page of FLASH.
15 years ago
Dean Camera
34047efc7e
Remove incorrect check for the current device state in the Set Configuration request handler of DevChapter9, which broke Set Configuration requests to the device under most circumstances.
...
Move out the SPI prescaler list to a PROGMEM module-level variable in ISPTarget.c.
15 years ago
Dean Camera
571159df1b
Additional fix to the AVRISP-MKII clone project for 256KB AVRs.
15 years ago
Dean Camera
cd0093a14b
Fixed AVRISP-MKII clone project not correctly issuing SET EXTENDED ADDRESS commands when the extended address boundary is crossed during programming or readback (thanks to Gerard Sexton).
...
Fixed warnings when building the AVRISP-MKII clone project with the ENABLE_XPROG_PROTOCOL compile time option disabled.
15 years ago
Dean Camera
d3c623e1e1
The LIBUSB_FILTERDRV_COMPAT compile time option in the XPLAINBridge and AVRISP-MKII projects has been renamed LIBUSB_DRIVER_COMPAT, as it applies to all software on all platforms using the libUSB driver.
...
Fix Benito makefile which was accidentally changed during testing.
15 years ago
Dean Camera
e277ff0cf4
Removed TeensyHID bootloader, per request from Paul at PJRC.
15 years ago
Dean Camera
05ac59d0ee
Add new ReportType parameter to the HID class driver device callback and host report sending routines.
...
Renamed internal Host mode Class driver descriptor comparator callback routines so that they all start with a uniform DCOMP_{Class Abbreviation}_ prefix.
15 years ago
Dean Camera
071e02c6b6
Add svn:eol-style property to source files, so that the line endings are correctly converted to the target system's native end of line style.
15 years ago
Dean Camera
e331b531c6
Change over instances of "make" in the makefiles to "$(MAKE)" to allow for the make tool to be overridden.
15 years ago
Dean Camera
57fe6b4fb9
Don't cast the line encoding baud rate to a uint16_t before performing the baud rate calculation in the Benito project.
15 years ago
Dean Camera
27eb17cb93
Change over unix line-endings to dos line endings.
15 years ago
Dean Camera
9c8bd6ed9b
Remove incorrect Abstract Call Management class specific descriptor from the CDC demos, bootloaders and projects.
15 years ago
Dean Camera
ab8668b14e
Removed software PDI/TPI emulation from the AVRISP-MKII clone project, as it was very buggy. PDI and TPI must now be implemented via seperate headers instead of the one unified ISP/TPI/PDI header.
15 years ago
Dean Camera
27f0ba6fc3
Fixed device state not being reset back to the default state if the host sets the address to 0x00.
...
Fixed Set Configuration requests not being stalled until the host has set the device's address.
Fixed possibility of internal signature retrieval being corrupted if an interrupt occurs during a signature byte read (thanks to Andrei Krainev).
15 years ago
Dean Camera
eed7d4df6a
Added new ENDPOINT_*_BusSuspended error code to the Endpoint function, so that the stream functions early-abort if the bus is suspended before or during a transfer.
15 years ago
Dean Camera
5c0c0327d5
Increase hardware PDI/TPI programming speed to 1MHz in the AVRISP MKII clone project.
15 years ago
Dean Camera
a5e79333e5
Switch back to C based timeout ISR in the AVRISP project - assembly version was failing, and only one or two cycles could be shaved off the compiler generated code.
15 years ago
Dean Camera
3d28d53c3e
Change AVRISP project's timeout to be interrupt based again, but make the interrupt itself interruptable and use a seperate assembly file to hand-optimize the ISR code.
...
Removed the cast to uint16_t on the set baud rate in the USBtoSerial project, so that the higher >1M baud rates can be selected (thanks to Steffan).
15 years ago
Dean Camera
9a1560dc05
Make sure that long reads are aborted early if the connection times out while waiting on more bytes in the AVRISP MKII clone project.
15 years ago
Dean Camera
ceb16ee24f
Make sure that the NVM bus/controller busy waits in the AVRISP MKII clone project abort properly if a timeout occurs while waiting for a response.
15 years ago
Dean Camera
e977774d4e
Relocate USBInterrupt.c/.h from the HighLevel USB driver directory to the LowLevel directory as it is hardware-dependent.
15 years ago
Dean Camera
59c4871f80
USB_Init() no longer calls sei() to enable global interrupts - this must now be done in the user application once all init code has run.
15 years ago
Dean Camera
85aaaf84ce
Make AVRISP-MKII clone project's software PDI/TPI mode more robust by keeping track of timeouts while waiting for a Tx/Rx to finish.
15 years ago
Dean Camera
5993e1efe7
Added ability to search by Channel PSM to the GetChannelData() function in the BluetoothHost demo.
...
Added new HCI states to properly initialize the bluetooth dongle and retrieve the local BDADDR.
Factored out Bluetooth state information into a new state structure for easy reference in the user application.
Added new StackInitialized() Bluetooth stack callback function.
15 years ago
Dean Camera
fc8e4837a9
Add const keyword to the demo function parameters where possible.
15 years ago
Dean Camera
5e14c194c9
Fixed Set/Clear Feature requests directed to a non-configured endpoint not returning a stall to the host.
...
Make TeensyHID bootloader use an 8 byte control endpoint to match the official Teensy, just in case Paul decides to authenticate on that attribute in the future.
15 years ago
Dean Camera
e55f338663
Document the Bluetooth ACL layer. Remove unneeded parameters from the signalling command processing routines.
...
Change over the code so that the bluetooth packet data is read in by the stack rather than the user application, to make it more unform for sending/receiving, and so the library can handle incomming fragmentation in the future.
Start Service Discovery Protocol decoding and processing.
15 years ago
Dean Camera
ee74b4948f
Add information request/response signal handler to the Bluetooth Host demo.
...
Ensure that the AVRISP-MKII project's Windows avrdude compatibility define is named properly in all parts of the code.
15 years ago
Dean Camera
fa1a092901
Add user callback function to the Bluetooth host demo to filter out connections from remote devices. Add in ability to reject connections based on their bluetooth device address.
...
Clean up RelayBoard project code.
Make AVRISP project clear the XMEGA target's reset register twice; this does not appear to take affect properly the first time under some circumstances.
15 years ago
Dean Camera
fd96b28882
More improvements to the incomplete BluetoothHost demo - add Disconnection Event processing.
...
Remove unused macro in the host mode demos for the maximum Configuration Descriptor size.
15 years ago
Dean Camera
c9148f9b47
Added WIN_LIBUSB_COMPAT compile time option to the AVRISP programmer project to make the code compatible with Windows builds of avrdude at the expense of AVRStudio compatibility.
15 years ago
Dean Camera
ce46257ff2
Add RelayBoard project patch from OBinou.
15 years ago
Dean Camera
3790907f4d
Added board hardware driver support for the Benito programmer.
15 years ago
Dean Camera
9257f4ab8e
Add briefs for the library core structures.
15 years ago
Dean Camera
74353374c3
All Class Driver Host mode demos now correctly set the board LEDs to READY once the enumeration process has completed.
...
Fixed Still Image Host class driver not resetting the transaction ID when a new session is opened, fixed driver not sending a valid session ID to the device.
15 years ago
Dean Camera
b8db5fc1e7
Added new Relay Controller Board project (thanks to OBinou).
...
Added hardware board driver support for the PJRC Teensy line of USB AVR boards.
15 years ago
Dean Camera
f79f9abd28
Fixed compilation error in the AudioInput demos when MICROPHONE_BIASED_TO_HALF_RAIL is defined (thanks to C. Scott Ananian).
...
Minor documentation cleanups.
Make sure HID class driver uses properly cast pointers when writing to the report buffer.
15 years ago
Dean Camera
4e99625f7c
Change over MIDIToneGenerator to use only a single channel (MIDI channel 1) due to cycle constraints.
15 years ago
Dean Camera
c58c53dba9
Added incomplete MIDIToneGenerator project.
15 years ago