- Homing now required before moving any axis.
- Software endstops now enabled to prevent crashing axes.
- Z motors now enabled at startup to hold Z axis.
- Controller fan now runs at 1/2 power at startup.
- Enabled LIN_ADVANCE with Z factor = 0 so that this can be set by a user.
- Disabled LED support on X MAX out of concern that a user may accidently short out their board.
- Re-enabled the Z offset graphics overlay that was pushed to upstream Marlin by us.
- Restored the look of the arrows since upstream decided to change it and introduced some missed pixels in the process.
- Adjusted build area to sit squarely in the middle of Foxglove/Euphorbia
build plate **
- Added fix to G29 for incorrect rewipe location on Foxglove/Euphorbia (T1458)
** When using this FW it is advised to adjust the wipe Y location in
the Mini start GCODE to Y=172
- Set Mini X_MIN_POS to -0.1, so X=0 does not ride against X_MIN endstop. This
prevents moves along X=0 from failing once a bed compensation matrix has been
loaded. This caused G29 to fail if used multiple times in a row.
- Before rewipe in G29, added move to (X_MIN_POS,Y_MAX_POS). This is a workaround to
prevent the Y coordinate shift duing G29 on older Minis from causing the rewipe to
miss the wiper pad.
- Changed Mini baud rate to 250000 since this is more reliable.
- Disable the extruder motor while probing on all Mini toolheads. This was
done before just on the Aerostruder, but I saw the same symptoms on a
standard toolhead on a Gladiola.
- Added Hibiscus_EinsyGearedMini2LCD variant.
- Increased TX_BUFFER_SIZE as recommended for ADVANCED_OK (may affect T1598, but does not appear to fix that issue)
Marcio Teixeira